Search results

Brand new MSD 2 step module purchased from AM. Hooked up all the pig tails to the coils, got the covers to fit, wired the blue wire to the white/red wire At the connector at the top of the clutch pedal. Set to 3500 rpm and I got nothing , just revs. Any ideas ? Am I using the wrong wire ?

I live near Boston. Looking to do a clutch job soon, and get the rear done with a full tilt boogie kit. Anyone know of any reputable shops in the area ? I got a great tuner an hour and a half up in NH but he doesn't do mechanical work Thanks

I've got BBK long tubes and Ive heard the trans doesn't come out without dropping the passenger header. BUT has anyone actually tried taking the tranny out ? And then bell housing as two separate units ? Anyone

Quick question hoping someone can answer for me. I have removed trans to do an input shaft and clutch, with TOB and sleeve. New cable and fork. With the trans out of the car, and the shifter on it, I can not seem to get reverse. Is this normal? Is it because the solenoid lockout isn't...

If this thread is still alive , I have a few questions. My TOB is shot , and I was planning on just having a shop pull the tranny because I have BBK long tubes (junk I know) planned on saying **** it and just doing a clutch as well while they're there My question is ... Can I just pull the...

Hey guys. 2.76 upper stock lower I've had the 100mm billet flow upper tensioner w/ new style idler currently running a k080745 , it's tight. Marks on tensioner are passed the halfway notch, I'm guessing a k080750 would fit better Alternator finally crapped out (factory one, car has 35k) got...

located in MA just outside of Boston all parts off a 2003 cobra with 33k on it BBK cold air stock TB and plenum BBK off road h pipe for long tubes - (was on the car for maybe 100 miles. it was too loud for my taste, went back to catted x ) stock IC resevoir Stock heat exchanger and lines...

i know this topic has been beaten to death and I have searched plenty and did some research on setups - but my car came with a setup I haven't seen anywhere else and I'm wondering if it's not a proper setup. It has your typical steeda oil separator on the driver side, but the passenger side is...

Hey guys I'm new to this forum, but not necessarily these cars. This is my first terminator, it's AWESOME (03 sonic blue hardtop) I have had a few in the past (03 mach1, 2002 + 2001 GT) but they were all mostly stock wheel and suspension setups. i just got some suspension (H&R sports - new...