Is it possible to bend pressure plate fingers? Doesn't look like even contact on the TOB.
Also think I found......pilot bearing material? See attached.
The install is a couple years old. Had some issues with engagement so I deleted the detent on the stock clutch cable and now it is doing this. I didn't replace the throwout bearing sleeve when I was in there and I think maybe it's wearing away? I should probably put an adjustable cable in it...
Please let me know your thoughts as to what's happening here.
It's a McLeod Street Extreme Ceramic Clutch with McLeod Aluminum Flywheel and Ford performance throw-out and pilot bearings. It's a stock clutch cable but I deleted the detent adjuster below the dash to allow the stock cable to be a...
Any tips on removing the egr tube. I've got it disconnected at both ends but can't get it fished out. Considering bending or cutting it. Should I be pulling it out from the top or bottom?
Thanks
So I sent logs to my tuner and he thinks something is wrong mechanically. I have replaced all of the above indicated parts. Not sure what else it could be. Could this be an injector sticking?? Here is a video of my issue.
04 Cobra 2.76 Eaton
340lph pumps pulse width modulated
Bolt ons
60 lb. Injectors
The car was tuned remotely and runs strong under wot. Tuned to lambda of 0.78 at wot and did all part throttle stuff. Week later I noticed an idle puls .
It happens if I clutch in and go into neutral at any kind...
I'm losing a moderate amount of fluid through this vent. Any explanations anyone? I dyed the engine oil to see if it was that but it did not show up as engine oil under the black light. Thanks for your time.