Looking for a fairly clean 1st Gen L to replace my 95' I sold (#1549)
-NO Rust
-Fairly stock, don't mind little touches
-Not opposed to project trucks that run good/need paint. (NO Rust)
-Preferably a Red/Black 95' with tube bumper and jumpseat but flexible
-$11,500 give or take a bit
-I'm in...
The factory nav system leaves some to be desired.... If mine fails I'll be dropping in a double din kit of some sort. Google Maps/Waze capability, audio selection and 911 assist notifications are the biggest complaints of mine.. Everytime I start my car it defaults to Line in, unless I left it...
Iv'e seen some get away with 285/35/20s on the rear. I'm doubtful you can go that same width on the front, Roush installs steering stops on the front of their 10-14 cars with the 20" options.
For the cost and time I still think you're better off just grabbing the cheapest 13/14 set you can find, get them cleaned and wrapped. Sold my cloth 13/14 set for 1500 and picked up a leather set (slightly regret). Still thinking about having the heat pads installed in them... Deals pop up on...
Found what I needed. Thanks y'all!
Looking to replace my 2014 trunk lid liner, not the trunk mat. Low mileage, non smoker preferred.
Thanks!
Found what I needed. Thanks y'all!
I believe Roush manual states 5w-50 for blower cars, track pack or not.
Factory Track Pack GT- 5w-50 Full Synthetic
Non Track Pack GT- 5w-20
All 3 of my 5.0 cars have had ticks after oil changes, after multiple oil analysis from Blackstone nothing was showing premature wear. My GTs saw redline...
I've always had a JLT passenger seperator on my 5.0 cars. Considering getting a UPR unit, I don't like the way the JLT "hangs" off the fittings on my Roush blower...
Ford changed something mid 2012. At the moment I don't recall if the connectors or passenger OCS was changed. I'll have to make a pass, I just picked up a complete cloth set on Ebay.
I'm interested if you decide to ship. Freight wouldn't be more than a few hundred at most, you'd have to grab a pallet and wrap them up pretty well though.
***EDIT***
Picked some cloth ones up on Ebay so I'm out of this deal. Shipping in crate shouldn't run more than $300 insured (I was quoted...
Some people pass/flake. You absolutely have first right to deal, I don't intend to step in the way of that. If you guys can't come to a deal then I am here to take him up on the seats. Funny that we both have an 14 'RS3 though!
BMR Rear Lower Control arms (adjustable)
BMR Rear Upper Control arm (Adjustable)
BMR upper Panhard support rod
BMR Panhard relocation bracket
BMR Rear Sway bar (Adjustable)
BMR Front Sway bar (Adjustable)
Poly bushings only!
Again, only looking for NEW parts. If you can produce a solid part...