Search results

Man idk I took it to a different tuner to have it tuned cause the original tuner did a bad tune the last time I went to him and then he stopped responding to my calls and messages after he said he would get everything straight but I also had spark blow out around 5600 rpm so I had to replace...

Ok I have a 97 cobra with a v2 s trim and air to air intercooler on it and my car will almost cut off when I run the ac at idle. But I didn't have this problem before I put on the intercooler,changed injectors and went from a draw through to blow throw maf. My car ran just fine without the...

OP I started with some 60lb deka injectors and a sct ba3000 but that was before I was intercooled. With the intercooler I went with a vmp maf and like ZeroDCX said it's up to you on what you want. If I could do it again I probably would have still brought a sn95 cobra but 1 much cheaper then the...

I have less then 1k miles on my frpp wires and I had the same problem until I put my stock wires back on if I have to replace them I will definitely go with some stock motorcrafts.

I used screaming demon coil packs but I swapped the old oem 1s back on and no difference. I'm starting to think it has something to do with the injectors or fuel wise cause I noticed my air/fuel ratio jumping around or it could be a vacuum leak I'm going to have to look into when I get a chance.

The plug was black and it had spark but really weak and yes cylinder 5. And I already had the wires and coils. The engine only has 67k original miles on it. The engine was warm when I tested it and yes the plugs had the correct gap my tuner checked behind me before he tuned it and I've had the...

I have a 97 cobra stock motor and it has a miss or is breaking up and it didn't occur until I got into it a few times within a 2 day period. I have new wires and coil packs and I found 1 plug that was bad cause I had a cylinder 5 misfire code. I did a compression test and all cylinders were in...

How do I check my low pressure switch on my ac? And here's my problem my clutch won't engage and I can spin the clutch by hand so it's not seized and I tried pumping some Freon in it in case it was low still nothing so i need some help in diagnosing this problem any help would be appreciated.

I'm looking to buy a complete air to air intercooler setup that will fit a 97 vortech cobra with the maf and bov thanks.

I have a 97 cobra and it's acting like it getting hot but my tuner said it was running in between 190-195 degrees when he turned it and says something is wrong with the temp gauge but it's cutting off when I hit the clutch to stop and after it warms up the fan stays on constantly and it has...

For the 96-97 cobra guys who pieced together their vortech kit what hose did you use to reconnect the diverter valve after you relocated it? I'm trying to figure out what temp rating hose I would need since I pieced mine together I didn't come with it.

I have a 97 cobra that I'm about to put a v2 s trim on and I'm wanting to know if I should try to start it after I do the install or just tow it to my tuner? And the only reason I'm asking this is because I want to make sure all the pulleys are lined up and everything is in working order so I...

I dont know if this is the right place to post this but what do you guys think about buying a short block already bulit vs buying a junkyard short block and getting it bulit or using your low mileage block thats in your car already to get built?

I'm looking for a 3.60 Vortech pulley thanks

Like the title says thats what im looking for if you have any of them items that you want to sell let me know and also looking for some 42 or 60lb injectors ev1s thanks.vortech products or anything that works

Hello guys I brought a used vortech v2 non intercooled kit and I need to know what MAF,injectors and fuel pump do i need the kit comes with a t Rex would that be good enough with the stock fuel pump? And the car is a stock 97 cobra with 65k miles on it any help would be thankful on this cause I...