Hey guys,
The diff decided to quit today on 03 cobra and not in a nice way.. it broke on a 2nd gear pull sending oil and metal pieces down the road. This is still a IRS car.
What are some options for swap, what fits, what's an upgrade etc would like some recommendations so I can start...
Hey guys,
Wanted some input or personal experience on the turbo lid that 2J Fabrication sells. Seems a cool idea keeping stock intercooler/ heat exchanger making it a A2W system.
Im going twin turbo and A2W is a nice setup, in addition I currently have a killer chiller which theoretically I...
Looking for some parts,
MM front coilover kit
MM control arms front
Oil filter relocation kit
99-01 cobra intake manifold or mach1
Lmk what you guys got.
Thanks
] Hey Guys,
Looking to swap out my stage 3 comp cams to smaller comp stage 2 cams to make the car more street friendly and help with some high IAT2 temps during idle and stop and go traffic.
What do you guys recommend degreeing the comp stg 2 at? I want to get some negative over lap and wonder...
As title stated looking for some parts for a project.
*T56 tranny, or broken unit for parts
*Cobra front/rear bumpers hood.
*Good condition exhaust for solid rear
Lmk what you guys have. Thanks
Hello all,
What is acceptable stft between bank1 and bank2 during rev holds ex 1500rpm 2500rpm 2500rpm etc
While working on my current tune I notice during idle my trims are close to each other within 5% but as the rpms increase there are points where there is a difference of like 15% ex...
Hey guys,
Just curious if someone can explain a little about my question below.
Lets say 03 cobra tuned big blower e85 making good power on 3" upper 4lb lower everything dialed in running like champ.. now if you swap to 3.5" upper running less boost, shouldnt the maf caculate and retune would...
Hello everyone,
Installed my magnum T56 this weekend in 03 Cobra with IRS, and had my driveshaft shortned by an 1 1/2" as per D&D suggestion. Im using the sonnax slip yoke which is a really nice piece.
I dont like how much the yoke shaft is sticking out, with rear wheels off ground its 1.5" of...
Hello everyone,
I read alot about the std inlet vs crusher inlet and there wasnt really a lot on info on it as far as hard data or numbers.
I swapped out the std inlet for the whipple crusher kit that comes with inlet and tb, intake 123mm etc . Other items changed were injectors and maf.
Same...
Need some advice if anyone experimented with IRS and bigger drag radials on a IRS cobra.
I currently have welds RTS 15x9.33 5.5bs and a Mickey thompson ET street S/S 275/50/15 and from 60 roll car breaks loose top of gear leaving tire marks down the highway. Lowered pressure to 19psi heated...
Hello all have a few items for sale, all items could be picked up in Westchester NY or buyer pays shipping and paypal fee.
Price drop
*ID1000 injectors on (3k miles on them) $750