Search results

Do you have the air dam installed to the bottom of the car?

2006 6.0 and a 2018 6.7

The body was in pretty rough shape, ot had some holes..

Wonder how long this has been sitting up in the mountains of NC?

Shes Hot too :)

Wife got a booty :)

All of the timing chain apparatus looked good. Maybe leftover from the last build?

I havent seen the pieces personally, The shop sent the pics. No 13/14 windage tray, the motor was built in 2006.

I already have Crower stage 3 blower cams in it.

Going to look at the timing chain guides.

I'm going to keep the 3650, look into beefing it up..

It's time for the 3650 to come out. Leaning towards the TKX. Thoughts?

Been having pump issues, losing fuel pressure, ect..sending DW300c pumps back to be tested. Replaced diaphragm in regulator, rewired everything, verified good grounds, correct voltage is getting to pumps, installed Aeromotive speed controller, MSD tach driver. Couldn't believe the trash on the...

I have a 97

So far so good with mine, just bolted it up.

In the old bbk throttle body it was blocked off, there is no inlet in the Accufab throttle body.

I have that tied into the pipe before the throttle body.

Idle Air Control IAC Restrictor Plate Fit for Ford Mustang V8 V6 GT 4.6 5.0 3.8 1986 - 2004 https://a.co/d/5ffMT6f

You have to cut that out. Dremel worked good for that. Stuffed a rag behind it and had the shop vac sucking the dust while i was cutting.

Check this out! Idle Air Control IAC Restrictor Plate Fit for Ford Mustang V8 V6 GT 4.6 5.0 3.8 1986 - 2004 https://a.co/d/5ffMT6f

I put a procharger 3 core race cooler on my car, flows nicely.

Switched out the pumps, made sure everything was ground correctly, adjusted the fuel pressure...was way too low, and the car runs strong.

Swapped.

I have a circa 2003ish tremec 3650 in my car, its about time to come out, what are the options for cars over 600 ft lbs of torque? I see the tko 600 or new tremec tkx..anything else? Suggestions welcome.