Search results

  1. slick3

    Trouble Deciding between Roush & VMP

    Looking to get into boost here toward the latter half of the year and have a few questions. The VMP kit in general appears to be the hot ticket with the PnP harness, the bigger heat exchanger pulley upgrades availible right in the kit. However there is one problem, I live in Komifornia and...
  2. slick3

    IE: Looking for Alignment Shop

    Looking for a quality alignment guy in the Rancho/Upland/ Fontana area My car is fairly low and most of the standard places cant even get my car on the rack, or at least I dont trust them to. Im about to call GTR and ask the who they would recommend but figure I would ask for some first hand...
  3. slick3

    5k Miles on Setup, Already creaking front end

    2014 GT M6 W/Koni Yellow, BMR Strut mounts flipped, BMR springs Only about 5-6k miles on the setup and am already getting some very annoying creaking come from the right front. Only audible when less than 10 mph, very audible when the wheel is at lock. No popping or thuds just creaking...
  4. slick3

    305/35/19 Pilot Super Sports

    Just picked up a set of these for the rear of some 19X11's I also have a 19X9.5 up front. Can someone recommend me a size that would work well with the larger OD of the rear (27.4) I was thinkning of a MPSS in a 275/40 or a 285/35? Suggestions? Thanks
  5. slick3

    305/35/19 non-dr?

    Looking for a non Drag Radial in posted size. Almost all available 305's are in 30 aspect ratio and its just to short for my liking. Im running F14's ....9.5F +? /11R +53 BMR SP009 Springs / Koni Yellow / Full BMR Rear Suspension I really want to run a 325 in the back but I think that will...
  6. slick3

    Trouble Data Logging Car/Bad Gas IE

    Rancho/Upland/Fontana area... Need a good gas station with some consistent 91. I have had shit luck at quite a few stations in Rancho with bad gas. My tuning process has been put on hold until I find a reliable station. Its either that or Torco at this point. " I know alot of you guys are in...
  7. slick3

    BMR Panhard Bar Wrench sizes

    Went out and bought the 3 wrenches that install paper said where required for adjustment (1 in, 1-1/16 in, 1-1/4)... Only the 1-1/16was of any use for spinning the threaded adjustment piece, jam nuts are too big for the 1-1/16 by a hair and 1-1/4 was too big. then again this was at the tail end...
  8. slick3

    Safe to run High Octane Fuel on Stock Tune

    Trying to chase down, what I believe to be a false knock issue. Just want to take it out of the equation. I am running 91 Shell at the moment and expierencing knock between 4500-5000k its only pulling 1.5* of timing but its enough that I cant get it tuned.
  9. slick3

    Steeda Catted X pipe... tune NECESSARY?

    I ask because im about to get this thing installed tomorrow.... Have a tuner coming in the next week but want to take my car into service before I flash it. Is it safe to drive with this thing as a DD for a week or 2? I dont want to burn the cats up or anything. Any insight would be appreciated...
  10. slick3

    Corsa Sport Quad Axel Back -Video inside**** X OR H Next?

    Sorry for the poor quality as this was my first time trying to do this. Anyway first video is cold start. Second video is at cruising speed under normal driving conditions and the last pull is WOT. I didnt have a ton of room so I couldnt really rip it. Hope this helps for anyone considering...
  11. slick3

    Corsa Quad install- One side is recessed into the gt500 Valence-HELP

    As title says, bought the Corsa Sport quad axle back with the gt 500 valence (Beautiful mufflers btw). The passenger side muffler sits exactly flush with the valence where as the driver side is outside of the valence by about an inch (Perfect fit). I moved the passenger side every which way I...
  12. slick3

    Recommend me an exhaust shop in the IE (Rancho/Upland)

    Just installed some Corsa sport quads and I have them aligned in the valence perfectly but the right side is recessed in the valence a good 1/2 inch to 1 inch further than the left. I need to get this fixed but am rather new to the area and dont want some yo-yo playing with my expensive...
  13. slick3

    Any fellow stang owners out in the IE?

    I just moved out here and im in the Upland/ Rancho area, just seeing if there is anything out there or any clubs in the area, I would love to meet up with some fellow stang owners etc..
  14. slick3

    Not Happy: Brand new 14 Track pack Already popping popcorn under the hood.

    Bought the car this Past Saturday, some of you might have seen my other thread helping me not get bent over by a less than helpful dealer. Anyways, here I am with the car I wanted (2014 GT Premium Trackpack), 315 Miles, and already not very excited about how things are playing out. Best way I...
  15. slick3

    Passenger Airbag Trim Sticking out

    Is this normal on these cars? I took delivery a few days ago and the TOP aluminum trim piece that is covering the airbag is sticking out on the lower right side. The panel is flush for the most part excluding the corner sticking out. Im going through the car and trying to find all the little...
  16. slick3

    Feel like the dealership is trying to stick me on 14 5.0

    There are some great factory rebates going on right now 3500 total on a new 5.0 premium w\ track pack. Msrp is 38209 and the are not budging at all on price. Except free first oil change :dw: Anyway, question is why kind of deal did you guys get n your 13-14 5.0s, how much off msrp, are they...

Top