Search results

  1. J

    New Mustang SVO

    I just bought a 1986 SVO I don't know much about these cars, but I really like the style and wanted one. Anyways I don't know much about them and want to know where to get started with mine. 1st thing I need to do is a tune up right away because it's misfiring. I usually buy NGK plugs for cars...
  2. J

    e85 requirements

    Looking to run e85 and was wondering what I needed for it? I have a 2014 Mustang Gt with a boss manifold and cold air intake, tune and full exhaust. Just wondering if I needed anything else besides injectors and what size injectors to get ? Thanks!
  3. J

    Intake falling off

    So I just installed a boss 302 intake manifold and my intake keeps falling off because the angle of where the throttle body goes is slanted, Idk if there is a forum about this already I searched and couldn't find anything. Anyways I re-installed the intake and it fell off again I made sure it...
  4. J

    2014 Mustang gt question

    I am just curious if this would fit my 2014 Mustang gt??! 2013 2014 Mustang Shelby SVT GT500 5 8L supercharger Blower Kit Ford Racing | eBay
  5. J

    Over heating

    I have an 03 Mach 1 I just replaced the timing tensioners on my car. After we went and did all the work my car is started to over heat now. I'm not sure what the problem is because before we did any of the work it was fine never even got past half way now it goes up like nothing. I replaced the...
  6. J

    Dyno results

    Well my numbers were 285hp & 300tq, mods are Bassani x pipe, borla stingers catback, c&l intake and 4.10 gears. Numbers sound right??
  7. J

    Shaker hose question

    I removed my shaker today and when I pulled it out I disconnected the hoses that were attached to the shaker, mine only had one and it was ripped I read that they were only used to drain water? Are they even necessary to have ?? Thanks!
  8. J

    Idle problem

    I've been having an idle problem since I bought the car, I barely bought it last Saturday. When I'm driving and I'm in between gears & when I put it in neutral to stop the car idles up to like 3k RPM and it stays there and takes forever to go down. I have to rev the car up over 3k and it will go...
  9. J

    Looking to get high 11's or high 12's

    I just purchased my Mach 1 last Saturday and it has a Bassani x pipe, borla stingers catback and thats it. I'm just wondering what I would have to do to my car in order to get it in the high 11's or low 12's without supercharging/turbocharging or spraying, thanks!

Top