Search results

Looking for a lower manifold if anyone has one available.

I'm interested in one if available

Complete IRS with FTBR kit, reinforced toe link bars, one axle has a DSS lvl2 bar upgrade and I have the bar and boots for the other side I just never got around to installing it. Only 6-8k miles on the FTBR kit and the car only had 36k when I pulled it to go solid axle. Would consider parting...

Was working perfectly when pulled, no damage anywhere on it. 75 shipped

Factory flywheel pulled at 30k miles as I went auto. 80 shipped OBO

Stock Bilstiens with 36k on them, only pulled to go to coil overs. 100 shipped

Used Drag bags with 3k miles on them. Lines were not cut to length when I installed them. Everything is included as it would be if ordered new. Looking for 75 shipped

15x8.275, 3.5 backspacing, 5x4.5 lug pattern. Bought these used off of a fox body before I found out that they wouldn't fit on my 03. There are a couple blemishes on them but nothing major. Just looking to recoup some money so I can get some wheels that fit. Only trades I would be interested in...

Plastic has a few blemishes in the packaging but the car itself is fine. 80 shipped OBO, not really sure what these are going for.

Plenum has been cleaned up a little with a sandpaper wheel inside, unsure of the mileage on the Accufab as it was on the car when I bought it. 325 shipped on the Accufab and 50 shipped on the plenum or 350 as a package. Prices are OBO

Set of stock cams pulled at 36k miles. $200 shipped OBO

I'm getting ready to go SRA and am looking at a set of Viking double adjustable coilovers. Car will be a street car with fairly heavy track use. I have no experience with choosing spring rates so any help or input is greatly appreciated.

Looking for a Trac-Lock unit for a build I'm doing, with or without gears.

Have a few used FRPS that I've acquired over the years. All tested good in my car when I got them, 20 shipped each obo.

Trying to find a decent deal on a fairly local Terminator. Prefer Screaming Yellow, Torch Red, or Oxford White but anything will be considered with the right mods and price. Not looking to spend more than 20K and willing to travel a little to get one.

Really only need the outer part that splines into the hub but would certainly purchase a complete axle for the right price

Purchased an 03 coupe that was rolled for some auto swap parts. Not much on the outside that is useable but pm

All parts were taken off of a 30,000 mile car for upgrades, all prices are OBO or TRADE!!!! stock coolant tank- $40 stock fuel pumps-$80 stock bolt-in subframe connectors- make offer 10 spline input shaft-$50 2 Factory flywheels-$100ea input shaft shim kit- make offer McLeod rxt 26 spline...

All parts were taken off of a 30,000 mile car for upgrades, all prices are OBO or TRADE!!!! stock coolant tank- $40 obo stock fuel pumps-$80 obo stock bolt-in subframe connectors- make offer 10 spline input shaft-$50 obo Factory flywheel-$100 obo input shaft shim kit- make offer Frps-...

Picked the car up this spring and haven't gotten around to working on it. Car has some damage to right rear quarter but doesn't look too major. Carb needs rebuilt or replaced (fuel to it just not through it) and brakes probably need some work. Have paperwork confirming it is a 20th anniversary...