AEM UEGO Air/Fuel gauge and wide band sensor - wide band sensor works great, no issues. All cables still like new. Only had around 3000 miles before car was totalled. Also comes with gauge pod for steering column - 140 shipped. SOLD
Steeda tri ax short throw shifter for a T5/T45...
Totalled car, selling some parts. Off of 1999 2v 4.6
Less than 5k miles on below
Ford performance 24lb injectors - $125 with ev6 to ev1 adapters.
Accell coil packs - $125. SOLD
Less than 10k miles on below
Accufab 75mm throttle body and plenum - $300. SOLD
K&N cold air intake - $100...
Yeah I forget who makes them but there is a company making bigger cams specifically for kenne bell 2v's so you don't have the issue. Most people either deal with smaller cams or move the bypass valve. I'm not sure about the pulley option either. I figured it would be same pulleys that guys use...
I would love to get some feed back from this kit. I have a forged lower end, cammed, port/polished pi head with full bolt ons. My end goal is 550 ish to the wheels. I honestly do not want more because this is a daily driver which rarely sees track time, and i dont want to break stuff non stop...
I'm going with AZMP. They seem to be reputable. I have been seeing a lot of people say stay away from some other shops around here so we will see i guess. Who would yup go through?
Thanks guys for the info it was very helpful! 7 bolts engine to trans, 3 starter bolts and then 2 bolts for the dust shield. Any ways motor is out of the car thanks guys!
I am removing just the engine through the top of the engine bay. My question is do I have to remove the starter? I have removed all 7 t45 to engine bolts and it doesn't seem to budge. Yes the motor mounts are free and everything else is to. The motor comes up just fine, however will not break...
Hi I am selling brand new never used ARP main stud bolts. They are in the box with all washers and nuts. This kit is the windage tray kit. Also I am selling with them a set of ARP side bolts. The side bolts are brand new as well, however they did get installed only to be uninstalled. I was...
Hi my name is Dustin I am trying to get rid of my 97 Cobra block and 96 Cobra crank with the ARP main and side studs. All are in great condition I am asking $650 for all. They have all been inspected by the machinist I use, the block is stock bore and the crank has never been turned. The...