I'm looking for suggestions for a drag suspension setup for whippled 6r80 3.15's. Confused about cradle lockout, diff bushings and vertical links. What do I need to lower 60ft times and try to minimize breakage?
Are there any tips or tricks you guys have for removing and replacing the 6060? I'm installing a new clutch on a lift. I've read through the 2011 Manual and assume the 13 will be similar with the exception of the cooling lines. Any insight is appreciated.
What are you seeing? My car has high IAT's in the 180-190 range at the end of a pass (low 50's ambient temp). The car goes flat due to reduced timing. I have a D1SC w Stage II cooler and 4.13 pulley. I see about 12 psi at 7100 on a 9.5:1 Aluminator. I need to get these temps down. I can put a...
Does anyone know the part number for Procharger's crank pulley that will fit the ATI Super Damper? I ordered a D1SC tuner kit a while back and didn't specifiy an aftermarket balancer at the time. I will be installing the Super Damper with my D1SC. Thanks
Does anyone know the part number or where to get the factory press in stud . It's the stud for manifold to cat converter flange? Ford parts doesn't even show a part number or availability. Thanks
What 1/4 mile times are all the normally aspirated GT automatics running. Could you also list your mods.
My best is a 12.514 @ 112.83 with Steeda CAI and Bama 93 race tune. My times and traps are low compared to some of you guys.:??:
I am looking for information to hook up RPM pulse to the RPM convertor. Should I tap into the #1 coil wire (pin 26 in pcm) or hook up a tack adapter/driver. Has anyone succeded in getting the RPM's to log properly?
Is it possible to install the Bassani headers on the engine when it is not in the car. My head is being replaced and I was wanting to have them install my headers. The engine was pulled out the top. Will they be able to drop the engine in and still thread the steering shaft through the headers.