Procharger D1SC off a 2004 Mach 1. Comes with all factory stuff needed to mount it. Also includes:
3.20 pulley
Non slip belt
Big Red race blow off valve
Boost pipe (adds more boost over factory intake)
SCT 2600 MAF.
Air to Air intercooler
This kit is ready to install. Just add fuel...
Hate to do this but have two machs and one needs to go.
2004 Mach 1,
5.0 livernois stroker motor,
procharger d1sc at 20lbs
maximum motorsports k member, coilovers, control arms in rear,
New from ford racing t56,
Completely built fuel system, and much more.
Very clean car. 36k...
Partin out a couple Mach 1's to varying degrees. Here are some of the parts I have. Let me know what you need.
Complete wiring system minus trans harness, Includes gauge cluster (104k), ECU, Key that is matched for PATS system and pretty much all you need for a 4v swap into a fox or whatever...
Selling some MISC parts.
04 Cobra oil cooler , pulled at 50k miles. $210 shipped
04 cobra MAF $60 shipped
AC system off 8k mile mach1. Includes everything except condenser. Has both lines, compressor and funny look cylinder next to the firewall. Thing worked awesome. $120 shipped Will...
I just ordered the PRP and I have a couple questions.
I am starting with my current tune that I know works pretty well from VMP.
I am adding a set of 5.4 cobra R cams. I know I need to adjust air/fuel and timing will be dialed in on a dyno....
1. So what else do I need to look at for...
Selling a like new BBK twin 65mm throttle body. Never installed but missing the bolts and gasket. Just comes with the throttle body so you will need to reuse your hardware. $275 shipped OBO.
Selling a couple mod motor parts.
BBK twin 65mm throttle body for 03-04 cobra. Just the throttle body. No screws or gaskets but pretty sure you can use the factory one. Never installed. Just sat in the box. $275 shipped OBO.
03 marauder upper intake $55 shipped OBO
Mach 1 DOHC timing...
Selling parts off an 04 cobra. Prices INCLUDE shipping but buyer is responsible for 3.5% paypal fee or send as a gift. Your choice. Parts all have less than 50k on them.
9 thread heads with cams, rockers, followers, tensioner and small chain / sprockets. $1050 Engine ran great and had good...
Selling some eaton swap parts. Selling as a lot. Take them all. Will split up if you want 4-5 things but not trying to ship one piece at a time.
Heat exchanger lines
Intercooler bracket
Intercooler resevoir
Coolant crossover
alternator with mounting bracket and pulley (50k miles)
Cobra...
Selling an 04 cobra motor with 50k miles. Runs and drives perfect. No smoke or issues. Has the nine thread spark plug holes. Includes:
Forged shortblock with 04 cobra heads
Mach 1 front timing cover
Oil pan
Exhaust headers with EGR tube
Coil covers and valve covers.
No supercharger...
Got a cobra ECM with catch code AMZ1. Came out a 50k mile running car.
$325 shipped to your door OBO.
Also have the dash harness. $100 shipped OBO
Main interior body harness $150 shipped OBO
03-04 mustang cobra T56, 50k miles.
Includes steeda triax shifter and stock cobra clutch /flywheel. Transmission mount is included as well.
$1800 OBO. Located in lawton, OK. Will ship at buyers expense or drive a couple hours to meet up.
Will consider partial trades for Modular C4...
--------------------------------------------------------------------------------
Selling eaton swap parts. Prices include shipping. Buyer responsible to add 3.5% for paypal fees or send as a gift.
03-04 cobra throttle cable with bracket $60
Cobra eaton side inlet with IAC and gasket $65...
Afco dual pass heat exchanger for 03-04 cobra. New.
Has sat around in a box for a couple months. has two hoses and installation kit just like you would get from afco. $320 shipped to your door or best offer.
Cobra driveshaft $260 shipped OBO
Just as the title says, selling a complete 03-04 cobra driveshaft. It is complete and comes with both yokes.
$260 shipped. Buyer to pay paypal fees or send as a gift. Your choice.
Parting out a 2003 mach 1 automatic with IUP and only 8k garage kept miles. Front bumper and frame is damaged but otherwise really nice.
Engine sold, front brakes are sold.
ALL wiring for car, PCM and gauge cluster are available for 1300 OBO shipped to your door. Thats every wire harness...
I am parting out my mach 1. Time to head another direction since i can't justify fixing all the little body (frame sadly) issues. Here are the details on the engine:
• 03 mach1 automatic engine
• 8k miles (can verify with odometer)
• Complete from oil pan to valve covers.
• No...
Selling some parts off a 5.4. Prices include shipping unless otherwise mentioned. Buyer responsible for paypal fee.
Timing cover (three bolt tensioner setup) $85
OEM Ford timing chain guides (all four) with two chains. Includes two piece timing gear as well. No reluctor wheel. 5k miles...
Selling a forged 5.4 rotating assembly. Less than 5k miles.
- Lightning 5.4 forged crankshaft. Standard size, recommend polishing but shouldn't need to go undersize. There were not any spun bearings or any issues. Balanced and ready to go.
- Manley forged rods with ARP bolts (not ARP...
I'm trying to clean out the garage a little. PM me your zip for a price shipped through Fedex. I'm open to offers especially if you want multiple things. Will consider trades for new forged rods or coyote / boss rods.
Aerospace EWP. Used for less than 6 months. $235
Upper and lower control...