Separate names with a comma.
Need it gone make me an offer.
I made 1215/1100 with the standard version. Lund made 1127 with the standard Gen 3. Lund made 1262/1035SAE with the Gen3R SS. So it does make...
The SS is a modified version of the Gen3 R that VMP sells so that would be off the shelf. My point is based off the gains from swapping to a...
The other question is would the 2.65 make 1250 with the better intake as well. I would like to see the 148 3.8 vs 148 2.65 graph.
[ATTACH] VMP 173mm T/B with ported adapter plate and gasket. This is the revised version of the 173. $400 shipped OBO
Standard inlet 4.5 is garbage.
Just like any other car it will take a good amount of $.
Over 2.5” x-pipe was with no cats.
The gains will be about 25whp with a 650-700hp combo with 1 7/8x3”.
YouTube? That combo should make 1200+ all day. You put your car on the dyno after the 2.65R?
What’s the goal for this combo Gen3R/ported heads/cams/10.5:1. 1250?
No the 3.4 actually had more timing in it IIRC.
Taking the 5th gen to TX2K?
The 3.8 should be capable of maxing out ID1300s. I would stick with the ID1700s.
Less the better.
Yea sure. Both on e85 cut with race gas out of a drum. Ignite 114 Red and One E. Both combos got the maximum timing based off plug readings on the...
Not going to make up for the 200whp difference. Also the 2.65 had 4.10s and a 30” drag radial. I think apples to apples it’s about 150whp...
I wanted to post this comparison awhile back but never got around to it. Yes these combos are not identical but they share a lot of the same major...
What tire did you have on when it made 13xx?
That or roll into it.
You going to put it back on a Dyno jet to see what it does on 28#?