Separate names with a comma.
I think you could get it done with under 1kwhp with a 3400# race weight.
Going to have to tune for the transbrake or it will hit the limiter on the 1-2. Might take some track logs to dial it in before the rental.
Very good passes this time of year. I don't even know how you can be out there in the middle of the day. I feel nearly heat exhausted working in...
-3-3.5 for rubber bushings
-2 degrees for poly bushings.
-1 for spherical joints
.... is a good starting point
I see no reason to not go with the 4.0 or 3.88, I'm running the 4.13 on a stock longblock. Your built motor breathes better which is likely why...
I'm on 15psi at least and my rods are fine so far. Whatever they are I got a good set.
Mustang... paid off.
'12 Civic EX that will be my sons 1st car....Paid off
'18 Sante Fe... [email protected]$375/mth
WTF is up with the grille? Tell me those aren't fog lights.
I work for Costco. We require masks to be worn. If you state you have a medical reason precluding you from wearing a mask we will not require you...
Catless longtubes, ported '18 manifold, Good tune (E85 if practical) and call it a day until you go boost.
you'd be surprised how much sauce a gen1 can take if the tuning and fueling is right.
Most of the tests you see are of a ported 18 vs a stock Boss. The Boss needs to be ported as the stock runners have a smaller cross section than...
Driven like stolen it should go very low 10'[email protected]
Last I heard was the dude ghosted some people with their cash. That's FB and Yellowbullet hearsay though.
Thx for responding Jeffs. Been kicking around the idea of selling my Procharger and picking this kit up with the 80mm upgrade.
When you're rocking 300hp showing someone your bumper is taking them to Gapplebees
Jeffs, why don't you give us some details about the install and any issues. Inquiring minds want to know.
I've been tuned by [email protected], Lund and AED. If I were picking a tuner today it would be PBD, with Lund a very close 2nd.
Bore gauge is best but plasti gauge will work too. I assume the machinist listed the clearances on the build sheet. No problem verifying them with PG.
bad alternator killed my ATX12-24. was looking at 11lb Brailles but they dont make a RH positive apparently.
Right on. Did your P1SC have straight cut gears?
Congrats on the new PB. What did you upgrade? Is this from last Friday? looked like rain was passing right over the track so I decided last minute...
Watching the video of your boost gauge it looks like it is building boost way too slowly. Trap speed is low also.
New PB turns a rough night at the track around real quick, congrats.