Separate names with a comma.
222 is boiling. 228 I shut mine down
235 lucky you didn’t blow coolant
a compression tester is cheap.
Our plugs are the easiest ever to pull...
Did they give him a quote to do just gaskets?
it can be a long job
What gasket was used on this year on stock manifold?
I did mine...
Go back to ford.
Share what information you have gotten.
my local dealer here I met with manager.
our oil cooler is said not to be fixable...
a basic test will show
mine purred at idle on 7 cyl s
a valve seat will drop, and piston will hit it and tap until it’s up enough to...
I had a knock noise before also.
Was clutch bearing blew causing fork to bang against transmission.
Clutch bearing is very common
I haven't listened yet but
I don't recall any passenger side issues
I've had 3 heads on drivers
Passenger is original 4 thread with over 400k
I would go off road mid pipe if you can still get it.
with long tubes it isn’t that loud unless on throttle.
Will get attention
I have a set...
very much. But strangely I just drove it today
Power or ground is getting lost
The 30a circuit breaker in aux box
Check this when fan stops
On ccrm pin 14/17 are triggers from pcm for...
have you done a compression test?
How old is radiator?
I had this battle on my 03
took a lot of leaning and testing but got it
In here svt documents page
scroll down to service manual
on that paragraph icon on top left is the button for the full version manual...
It’s a radar jammer
Vote also for at least a basic compression test.
ours. Head issue and 60k is about what ours lasted.
Originally 4 thread
Than 1st design 9...
Dropbox - 20210329_140651.jpg - Simplify your life
Dropbox - 20210329_140747.jpg - Simplify your life
1 behind wheel
1 at pumpkin
On 03 dropping cat back takes mins
Held with rubber bands and 4 bolts
the rear at tail has a slide off mount once front half is off
wd40 big bar...
Cool thread. Talking with my son now about this with a twist.
Im in Texas. He is in Indiana
I had vehicle given to me,but haven't done...
I did mine on ground
backed up on ramps
Pulled cat back exhaust
used a floor jack to lift frame.
And than a come along to pull frame...
Getting it lined up and stay in place is just a little tricky.
Test your skills
I did mine in driveway so it’s not hard in any way
Fun to install these also ,
Can see why ford did what they did,
Think 4 inch was what I got
think full tilt boogie has photo for reference
Motor mounts are another area overlooked
Thankyou for fixing Bob and robvas
Yes that plug
And yes it is effect because it gets hot and cold
Barrels not fully over pins
as wires get hot when working it expands and stops...
Something I found on mine after yanking stuff
the fan connector. the fan side.
Has barrels. These on mine were back to far causing to go on...