Separate names with a comma.
And that one time you forget to run it, you will pop that motor...lol
I use the BF Goodrich G-Force Comp-2 A/S for winter driving.
What was the outcome? Did you end up starting over?
Not GT500, but have it on my Coyote. Replaced a Twin67. Drivability is the same, lost a little down low, but gained way more on top from seat of...
The strut brace is for a 2007-2009 Cobra. Works great. I had to trim the padding under the hood a tad, but no big deal.
After buying the stage 1 kit from AM, then buying upgraded HE, throttle body, etc. from VMP, I wished I would have just went straight stage 2 or 3...
Is this ARB in this thread the one you spoke about above?
Thank you very much. The initial tune that is still on it. I am playing catch up with other things due to fixing issues with the car. I am...
Thank you very much. The bank 1/sensor 1 went out as well. Changed it, no go. I cut off the sensor from the old one, and plugged it in, ohmed...
Same here
Just to finish up thread, flashed new PCM, all is good now. Now to get VMP some datalogs to smooth out the motor.
Forgot to add, yes, I installed the TVS, along with billet OPG and CSG, Kooks super shorty headers, Pypes cat deletes and x pipe, magnaflow cat...
Thanks for the response basspro. Yes, I installed the TVS per the instructions from VPM (not very good BTW). Multimeters are absolutely the...
Well, first off, I have a code of P0098. , which is Intake Air Temperature Sensor 2 Circuit High. I have a good sensor, and measure the correct...
Can I just take the PCMs? Does the car need to be at the dealer?
I am speaking about if you are having a PCM bad or going bad, and are boosted, what is the correct way to get it swapped out?
What is the correct method you have to perform to flash a new PCM and swap out the old one with FI at the dealership? Do you even have to take...
I don't know why anyone would not spend the extra coin ($150?) on the driver's side on keeping oil vapors out of the intake tract. Over time, it...
I installed Boudary OPG and TSS CSG. The Boundary OPG would not turn in the OP housing. I called Travis at Boundary, and I ended up sending him...
I have the passenger's side, and will be getting that driver's side as well. I see no reason not to, especially since it still pulls oil vapors...
Will this sale ever be offered again?
I have pulled the front bumper, fan, radiator, accessory belt. I will move the compressor today to access that one nut behind the ac lines. My...
First post here, and am in the middle of installing the Kooks Shorties myself. My issue is, that I am stuck at the forward upper nut on...
