Separate names with a comma.
I would not touch it with a ten-foot pole I would spend a little more money and get one with a clean title you could end up regretting that purchase
Et street r bias smoke the radial pro have had them both I will never buy a radial pro again
My friend owns Hammer performance here in El Paso Texas he refuses to install their drive shafts the DSs because of problems without U-joint...
Shaft masters is a better drive shaft
Which kit did you get I personally like the hellions sleeper kit so much I'm thinking of buying an 18+ so I can put that kit on
I have kooks for all the work that it is to put on a set of headers buy nice headers kooks makes the most power and they sound the best
I will buy the throttle body if you'll separate it and give me a good price
my intake is still fine never blown it off never had a nitrous backfire you just have to use the stuff right it has its pros and cons like...
I have a 14 that has over 200 horsepower sprayed in it have sprayed it for 5 years never had a valve cover off the motor no oil pump gears makes...
Mine shifts like that was tuned by Shawn at aed
Aed did a great job for me
I've had my Circle D 4C converter in for 2 years I barely hear a whine at idle almost like an idler pulley barely starting to go out and you can...
I have a boss manifold stock throttle body had lethal xpipe made 385hp 369tq put kooks 1/7-8 lethal ota pipes made 426hp 376tq same dyno
Are you still on the stock motor
I learned the hard way throw their wide open switch crap away and buy an nos mini progressive controller
3rd is when my 4c locks up
12 to 1
My boss manifold stock throttle body Cook's 1 and 7/8 inch headers 3 inch off road X lethal 4C converter made 426hpto the tires 376 torque
I've been looking at your engines andand I'm trying to figure out what I want I have a 14 5.0 Circle D 4C converter boss intake direct Port...
I have Cooks 1 and 7/8 inch headers Offroad X lethal over the axle pipes MagnaFlow streets not that loud sounds great
Why don't you just raise the rev limiter a little bit I rub mine to 7500 RPMs
I found 12 lbs hooked the best I also love the bias ply Mickey's way better than radial pros
I race at altitude so you have to take this in consideration the DEA is usually about 6,000 feet I ran a 1256 at a hundred and nine on the motor...