Separate names with a comma.
I'm running a stock 3.75" upper on my KB 2.8h with a 4lb lower. Yes it is on E85.
Gained almost 100 hp raising the CR with the same pulley combo.
I had it tuned locally. Made 785hp and 702tq. My injectors are at 95% so I need to go bigger.
I'm running 22 psi on my 10.4CR motor. The main thing is you cannot run a lot of timing with high CR. They do not like it.
Definitely looks clean for 17k. Buy it.
I also recommend Gear box. Very knowledgeable and great service. Used them a few times over the years for parts.
The Gear Box is your online...
I get 120- 150 miles to a tank in my car on corn with mainly cruising and a few small hits.
I have a built motor, cams, 10.4 CR and 21 psi of...
Should be knocking on the 800 door for sure.
The largest pulley on the bottom is the lower.
Looks like a steeda pulley to me. Again, measure the pulley diameter where the belt goes. Same with lower.
I've only been to the Surfside location. I had the baby back ribs and my fiance had the NY strip and the steak was to die for. Blew my ribs outta...
California Dreaming was delicious as usual Friday night. A lot more people there than I expected to see there. Bar tenders said it was still slow.
Went back to my condo today, no real damage. Can tell the water was up pretty high though from the beach. Had about 2ft of sand on the path to the...
95 Cobra R replicas with assembly bolts. You can check American Muscle or LMR to get a price of what they cost new and go from there.
Here is my cam card and a round of measurements. I had a typo above sorry. Corrected it now.
Both cams do not degree to the 114. The exhaust cam is a calculated value. You need to take the difference of your intake cam (114 you said) from...
Have a last minute appointment at 9:15, heading out after that. Hoping 10:30 the latest, but will see how that goes.
Loading up today and heading out Friday morning to NC, be at the beach Saturday morning.
Heading down Saturday to Sunday. Cant wait for it!
Sounds legit. Hope you plan on running E85 with that CR.
Sounds like the FRPS crapped out. Replace it, hold the gas pedal to the floor and crank it over 10-15 seconds. Wait a few minutes and start it...
Sub'n. I'm in the same boat, 800 rw on my 80's. I just haven't justified $1500 injectors yet.
Check the little yellow wire on sender. Sounds like you broke it. I re-soldered mine when I broke mine. The float does not have steps, it will...
You will not break the crank with an Eaton. People who have snapped the crank are running large aftermarket blowers.
MHS .500" Lift 4V Stage 2 Valve Springs
MHS .500" Lift PAC RPM Series Stage 3 4V Valve Springs
PAC makes the springs for a lot of companies out...
Check PAC springs or Modular Head Shop. They will have what you need.