Roger that, if you figure it out, let me know.. 150 bucks to swap out the bearings and a new seal. Would have cost me more if I would have ****ed it up I suppose. I just don't see any other way for it to come apart.
Searched all over the internet for some pictures or a how to for taking apart a snout and replacing bearings. Blower is a 2.0 KB with a snout upgrade.. (confirmed the blower with KB) The only thing I found was an old thread on a Dodge forum. According to that, the shaft should come out the...
Do not do this. Even at idle it will be super rich and you risk washing cylinders down. This will do way more damage than leaving ethanol in the fuel system.
The first couple years I used to run the tank down and fill with 91. Been leaving the E in since 2013. I can't remember the last...
OASIS for you
VEHICLE DESCRIPTION2003 Mustang
ENGINE4.6 DOHC EFI S/C
TRANSMISSION6 Speed Tremec ASM T56
PAINT COLORSILVER MET WATERBORNE
RADIOCDX6+ RAD W/ SP SENS VOL CONTR
AXLE RATIO3.55 FINAL DRIVE RATIO
WHEEL SIZE17 X 9...
Any of you guys familiar with the 4th Street Cruise in Waterloo this weekend? Going to head down on Saturday and was wondering if there was a good spot to sit and watch cars roll by, maybe with a public restroom close?
Bought these new to use for a cast iron Romeo block. Not the correct ones. I believe they fit aluminum blocks? Opened but did not install. 70.00 shipped to the lower 48. Buyer to cover the fees or send FF.
Forgot to mention, they are standard size.