Transmission Lines/Schematic

Looking for confirmation and a better understanding where the lines run and where the breather valve or pipe is located on these transmissions?

I understood the breather line to be positioned on the passenger side?

TRACK Pack setup so it obviously has the transmission cooler with additional plumping. I want to know where those additional lines are located in relation to the trans.

The other question here is, can you overfill a transmission?

The breather/vent is separate from the overfill. I've never seen the vent but probably at the top somewhere.

If you look part way up on the passenger side there is a plug. That is the fill and overflow all in one. Drain tranny out the bottom. Put bottom plug back in. Fill from the side until it flows out the hole. Screw in plug done.

As far as the cooler lines. Shouldn't be hard. There will be two lines going from the tranny to the front. One goes, the other returns.

Tom

The vent had a line on the 07-12s that ran up the back of the bell housing. The 2013 transmission I bought just has a vent cap at the transmission vent outlet. It's just off center of the shifter linkage on the passenger side.

I think you could overfill it, if the car wasn't level when you added fluid (front lower than rear). The fill plug is pretty far back on the transmission housing.

Check out post #18 in this thread: https://www.svtperformance.com/threads/pressurized-transmission.1043558/