This is a turnkey twin turbo set up for a 4.6 4V. This set up is currently on a car and has been well proven and run so install and fit will be spot on. It has made 1200rwhp on the dyno and has run 155mph in the quarter.
It includes the custom sheetmetal intake, BBK twin blade TB, fuel rails with 120# injectors, PTE 6262 billet wheel turbos with 38 mm Tial wastegate and Tail blow off valve. ALL hot and cold side plumbing which should work with factory accessories and AC. Headers are custom mild steel with wrap and down pipes and to axle exhaust with turn downs. IC is also custom made and works very well and I dont believe it is a Chinesium piece. I believe it is an American made bar plate core. Hot and cold sides were custom built by the shop that built the car around 2008 The turbos are mounted in front and low and it uses a scavenge pump which is also included along with all the AN oil lines and fittings. The intake is a custom sheetmetal intake with FWD facing BBK twin blade TB and billet fuel rails.
$8500 includes all plumbing hoses brackets clamps and fittings. I am located in Youngstown Ohio and prefer in person deal but willing to ship. Shipping will most likely need to be truck freight and will be at buyers expense. The parts are still on the car which does run and I don't plan to remove them until I get a commitment to buy.
I will also be listing the fuel mgt system which is a fully optioned BS3 with a Racepak dash and datalogger. I may also be selling the motor.
It includes the custom sheetmetal intake, BBK twin blade TB, fuel rails with 120# injectors, PTE 6262 billet wheel turbos with 38 mm Tial wastegate and Tail blow off valve. ALL hot and cold side plumbing which should work with factory accessories and AC. Headers are custom mild steel with wrap and down pipes and to axle exhaust with turn downs. IC is also custom made and works very well and I dont believe it is a Chinesium piece. I believe it is an American made bar plate core. Hot and cold sides were custom built by the shop that built the car around 2008 The turbos are mounted in front and low and it uses a scavenge pump which is also included along with all the AN oil lines and fittings. The intake is a custom sheetmetal intake with FWD facing BBK twin blade TB and billet fuel rails.
$8500 includes all plumbing hoses brackets clamps and fittings. I am located in Youngstown Ohio and prefer in person deal but willing to ship. Shipping will most likely need to be truck freight and will be at buyers expense. The parts are still on the car which does run and I don't plan to remove them until I get a commitment to buy.
I will also be listing the fuel mgt system which is a fully optioned BS3 with a Racepak dash and datalogger. I may also be selling the motor.