Which MAF do you guys recommend to go with my Gen4 2.9 crusher?
Thanks!
Thanks!
Which MAF?
- Thread starter Chrome98Cobra
- Start date
Aren't those set up for a slot style MAF? I had good luck with the BA5000 in the past, but its a "big" MAF.
Sent from my SM-N981U using Tapatalk
Sent from my SM-N981U using Tapatalk
Last edited:
It is.
Looks like my two options are SCT BA5000 or the GT500..
Looks like my two options are SCT BA5000 or the GT500..
Figure out what boost level you're planning on running then go from there.
I ran a BA5000 in a 3.5" tube in a blow through set up and was only using about 3/4 of its range. That was at 19psi on a big bore set up.
Sent from my SM-N981U using Tapatalk
I ran a BA5000 in a 3.5" tube in a blow through set up and was only using about 3/4 of its range. That was at 19psi on a big bore set up.
Sent from my SM-N981U using Tapatalk
A GT500 sensor or just 05+ GT sensor (they're the same) should get the job done. I'm pretty sure @MalcolmV8 ran a BA5000 in the crusher setup initially but had to change it because of resolution issues.
Users who are viewing this thread
