If you bought a custom fuel hat (like Cpe/Division X or Radium) and you wanted to add additional wiring that goes through the bulk head to the pumps, what would you use to then seal up the hole with the wire running through?
Is there a solution that allows multiple wires in a bundle to go through the same hole or is it just better to give them each their individual penetration? (I'm assuming a bundle is harder or impossible to seal properly).
What compound would seal up nice and firm and be resistant to all fuel types (93, E-85, etc)?
Is there a solution that allows multiple wires in a bundle to go through the same hole or is it just better to give them each their individual penetration? (I'm assuming a bundle is harder or impossible to seal properly).
What compound would seal up nice and firm and be resistant to all fuel types (93, E-85, etc)?
