Throttle stuck

CobraBob

Authorized Vendor
Established Member
Premium Member
Single Barrel Sirs
Joined
Nov 17, 2002
Messages
105,502
Location
Cheshire, CT
o_O:rolleyes: @MysticCobra1076, forget about trying to pin this on Ford. LOL. It does suck that your Mystic Cobra is toasted and dead, but geez.....!

I'm posting the info below for you the next time it happens when you go WOT in the wrong place at the wrong time.

How to react if malfunctions or external interferences cause unintended acceleration.

132-gas-pedal-sticks-wide.jpg

It doesn't happen often, but when a gas pedal sticks or malfunctions, the situation is frightening and extremely dangerous. In an instant, the vehicle can accelerate to full speed and become unresponsive to braking efforts.

Mechanical malfunctions - such as a faulty throttle, external interferences, a floor mat that wedges under the pedal - can contribute to this type of unintended acceleration.

Below are 8 quick ways that may correct the issue and remain safe in an emergency situation.

  1. Stay calm and try not to panic.
  2. Push the brake firmly with both feet and hold it down. Don’t pump the brake pedal or release it because you will lose all your vacuum power assist, causing your brakes to become stiff and very hard.
  3. Shift the car into neutral. If the car has a manual transmission, remember to depress the clutch to shift gears.
  4. Steadily hold the brake and look for an escape route, like a hard shoulder on the highway. Avoid quick lane changes, which could cause you to swerve and lose control of the vehicle. If possible, steer in a straight line.
  5. Do not turn off the engine unless shifting into neutral is unsuccessful. Turning off the engine will turn off the power-assist brake functions, making it harder to maneuver the car.
  6. When you have come to a controlled stop out of the way of traffic, turn the engine off (if you have not already done so). If you use a key, keep it in the ignition when you turn off the engine so the steering wheel doesn't lock.
  7. If your vehicle has a start on/off button, hold the button down for at least three seconds to disable the vehicle. Do not tap repeatedly.
  8. Call for assistance. Do not drive the vehicle until it has been professionally serviced.
 

AustinSN

Well-Known Member
Established Member
Beer Money Bros.
Joined
Jan 29, 2014
Messages
6,408
Location
the plains
Had a buddy who had a throttle stick on his explorer because he installed an aftermarket intake tube and it hung up the cable.

Fortunately back in that day we worked at a full service car wash and were trained to deal with the throttle sticking problem due to the Jeeps that would come through.

Click it into neutral, turn the ignition off, come to a stop.
 

MinGrey02Stg2

Well-Known Member
Established Member
Joined
Apr 18, 2004
Messages
2,448
Location
FL
Yes OP I have heard of the issue and it seems to be a huge problem with Mustangs especially. Here's a documentary with examples of the problem. Good luck with your claim to Ford.

 

jaxbusa

Well-Known Member
Established Member
Joined
Sep 29, 2015
Messages
688
Location
Northeast Florida
I have a 2 valve so it might be different from other experiences. When it happened to me I just finished up placing my Amazon order and pushed in the clutch.


Sent from my iPhone using svtperformance.com
 

apex svt

MEAN STREAK
Established Member
Joined
Jun 29, 2012
Messages
2,166
Location
USA
There's a TSB for 03/04 Cobras about the throttle pedal getting stuck on the carpet. The fix was a piece of plastic to cover the corner of the carpet. I'm not sure if that's the same for the earlier models. My 01 didn't have that problem.

6EDB607A-88DB-428F-A0FC-958159F63007.jpeg


I have the “fix” never leave my floor mats in because it will get stuck 80% of the time. Horrible feeling.
 

zak88lx

Future SVT *****
Established Member
Joined
Jul 15, 2008
Messages
2,578
Location
Calgary, Alberta
Description: on certain mustang cobra passenger vehicles, the rear surface of the accelerator
pedal may come into contact with floor carpeting during heavy throttle application. the unique
surface profile of the accelerator pedal may catch in the cutout on the floor carpeting behind
the accelerator pedal.
this could interfere with the pedal's ability to return to an idle position. unexpected, continued
throttle application and/or increased stopping distances may occur which could result in a
crash.

Remedy: dealers will install a shield over the cutout in the carpet behind the accelerator pedal
 

Lambeau

Superfleck Moonbird
Established Member
Malt Liquor Mafia
Joined
May 13, 2010
Messages
9,842
Location
Rockwood Lodge
Description: on certain mustang cobra passenger vehicles, the rear surface of the accelerator
pedal may come into contact with floor carpeting during heavy throttle application. the unique
surface profile of the accelerator pedal may catch in the cutout on the floor carpeting behind
the accelerator pedal.
this could interfere with the pedal's ability to return to an idle position. unexpected, continued
throttle application and/or increased stopping distances may occur which could result in a
crash.

Remedy: dealers will install a shield over the cutout in the carpet behind the accelerator pedal

Source?
Date published?
 

hotcobra03

Well-Known Member
Established Member
Joined
Mar 11, 2007
Messages
7,466
Location
poteet,texas
Description: on certain mustang cobra passenger vehicles, the rear surface of the accelerator
pedal may come into contact with floor carpeting during heavy throttle application. the unique
surface profile of the accelerator pedal may catch in the cutout on the floor carpeting behind
the accelerator pedal.
this could interfere with the pedal's ability to return to an idle position. unexpected, continued
throttle application and/or increased stopping distances may occur which could result in a
crash.

Remedy: dealers will install a shield over the cutout in the carpet behind the accelerator pedal


What I see.

Mine is taped already to center hump.

Just above tape the carpet rolls over.

This is where pedal gets caught.

Fix from ford manger to me was.

A lager flat metal plate is added for rolled piece of carpet to be taped to.

I told him. Recall the head and seat belts. I can cut the carpet
 

ViciousJay

Well-Known Member
Established Member
Joined
Nov 22, 2004
Messages
20,266
Location
Chi Burbs
Throttle pedal got stuck on me in my 04 Cobra at the track, I ended up dumping it into N and pulling and releasing the e-brake with a puckered @sshole. When I was able to fully stop I limped the car back scared and used a razor blade and cut the carpet out, ever since that day everything was fine
 

BlckBox04

I am the liquor
Established Member
Premium Member
Joined
Dec 24, 2007
Messages
8,543
Location
NJ
bro did you have the ****ing throttle pinned in a residential neighborhood? not a chance in hell normal cruising would get the throttle stuck WIDE open and you not being able to stop.
 

Users who are viewing this thread



Top