2011 GT500 - Lowering fuel tank question

PM-Performance

Well-Known Member
Established Member
Joined
Dec 16, 2015
Messages
1,224
Location
Blandon, PA
I don’t see a question, but it’s not hard.
Support the tank with a block on top of your jack and loosen the strap bolts so it drops on the jack.
Then lower your jack a little and you will have Access to the tunnel if that is what’s needed.
If you want to fully remove it, then obviously you remove fuel lines and drop it.
 

Catmonkey

I Void Warranties!
Established Member
Premium Member
Joined
May 20, 2011
Messages
3,854
Location
Louisiana
I would drain the tank to do it too. You can get a tune revision that makes the fuel pump run in accessory mode. Be careful, it will fill a 5 gal gas can quicker than your think. Don't ask me how I know that.
 

Robert M

800 HORSE FUN!!
Established Member
Joined
May 15, 2003
Messages
9,157
Location
Sunny, Fla.
Don't forget the TP50 torx, a T50 does not fit the bolts properly and can strip out the head causing a bigger problem.

Thicker spline TP50 left.....

002-zps40e8f2cf.jpg


..............and a fuel tank strap bolt that was removed with an incorrect T50 torx bit......almost stripped out.....

003-zpsc7142a6e.jpg


R
 
Last edited:

Pribilof

Life's Better @ Elevation
Established Member
Joined
Oct 15, 2013
Messages
1,162
Location
Denver, CO
I have a TP50 from SnapOn. Lisle now has one available too (for much less $ than SnapOn, obviously). You definitely do not want to use the standard T50 on the gas tank bolts.
 

Users who are viewing this thread



Top