4.6 2v 4v head swap

V8 Ford Ranger

New Member
Established Member
Joined
Apr 6, 2020
Messages
10
Location
kansas
So I have a 4.6 2v swapped ford ranger and I would like to go 4v. I found a Lincoln continental that I could pull the heads off of. I have 10cc PISTONS that would up the completion at 9.65:1 with the 4v. I know that the bell housing is different on those engines but would the front cover fit on my 2011 4.6 2v block? Also, the throttle body sits in the back of the engine facing up in a bad spot. would an aftermarket intake manifold like for a cobra fit on those heads.
 
Last edited:

Saleen498

Well-Known Member
Established Member
Joined
Oct 21, 2017
Messages
1,183
Location
Commieweath of MA
Yes, the part number on the Lincoln continental heads is exactly the same as the part number on 04 cobra heads. The timing cover is the same as the mach 1 and aviator I believe. And cobra/mach1 or aftermarket cobra/mach1 intake manifold will work.

and Jeffrey Epstein didn't kill himself.
 

V8 Ford Ranger

New Member
Established Member
Joined
Apr 6, 2020
Messages
10
Location
kansas
Yes, the part number on the Lincoln continental heads is exactly the same as the part number on 04 cobra heads. The timing cover is the same as the mach 1 and aviator I believe. And cobra/mach1 or aftermarket cobra/mach1 intake manifold will work.

and Jeffrey Epstein didn't kill himself.
ok thank you for the help its time to smoke those S10
 

Users who are viewing this thread



Top