Terminated Mach 1 Results

SS EATR

Active Member
Established Member
Joined
Feb 22, 2011
Messages
903
Location
La Crosse VA
I got to test out my winter build at the track a couple weeks back. I blew a headgasket at the end of last year so I also upgraded to a set of custom blower cams with springs. I have a 03 Mach 1 that has been terminator swapped, and the car made 629/554 to the wheels through the 4r70w. Im running around 20 PSI on a 2.3 VMP blower with a 110/93 fuel mix. Here are the results from the 1/4 mile run, going to make a few more changes and get the tune dialed in a bit better and hopefully see mid 9s.

986_zpslobovkfc.jpg
 

blownstang4.6

Active Member
Established Member
Joined
Nov 8, 2011
Messages
469
Location
Chicago
Awesome! Mine makes 508/436 on the stock motor with a Vortech through a 4r75w. Should go 10.90's at full weight once I get a chance to run it. Ran 11.37 a few years back when it made 452/386. Once I forge the motor and give it a little more timing on E85 I'm looking to be high 9's. Have a cobra shortblock laying around to use, but will ditch the low compression pistons for some in 10.5-11.0 range. Stock heads/cams, Vortech V1 S at 14psi and about 18-19 degrees of timing should make around 660. Fuel system on E85 will be maxed about there and I'm not pushing it any further.
 

BlckBox04

I am the liquor
Established Member
Premium Member
Joined
Dec 24, 2007
Messages
8,496
Location
NJ
what rpm are you running through the trap at?
 

BlckBox04

I am the liquor
Established Member
Premium Member
Joined
Dec 24, 2007
Messages
8,496
Location
NJ
yea you don't want to go through all that work swapping gears and then find out you're out of gear at 1000' mark
 

SS EATR

Active Member
Established Member
Joined
Feb 22, 2011
Messages
903
Location
La Crosse VA
yea you don't want to go through all that work swapping gears and then find out you're out of gear at 1000' mark
Oh yeah that would suck lol. I'm going to double check before putting them in to be safe, but i'm pretty sure I'll be fine.
 

CobraBob

Authorized Vendor
Established Member
Premium Member
Single Barrel Sirs
Joined
Nov 17, 2002
Messages
105,349
Location
Cheshire, CT
Definitely very impressive performance. Nice mods. Your Mach, I mean TERMINATED Mach, is freaking beast!
 

Frankyv14

New Member
Joined
Oct 3, 2019
Messages
1
Location
Paris
Awesome! Mine makes 508/436 on the stock motor with a Vortech through a 4r75w. Should go 10.90's at full weight once I get a chance to run it. Ran 11.37 a few years back when it made 452/386. Once I forge the motor and give it a little more timing on E85 I'm looking to be high 9's Crédit travaux. Have a cobra shortblock laying around to use, but will ditch the low compression pistons for some in 10.5-11.0 range. Stock heads/cams, Vortech V1 S at 14psi and about 18-19 degrees of timing should make around 660. Fuel system on E85 will be maxed about there and I'm not pushing it any further.
It's a big project, I just hope you can bring it to fruition.
 

Users who are viewing this thread



Top