Max Motorsports strut tower brace

bfgtim

Member
Established Member
Joined
Jul 27, 2017
Messages
237
I’ve got a mmstb-7 installed on my car.
I currently have the OE Easton blower but want to switch to a vmp tvs with the gt500 tb
I’ve been told by vmp the strut tower brace will not fit over the vmp tvs
My plan was to switch out my mmstb-7 for a mmstb-8, which is intended for use with supplies/kenne bell sc’s

Has anyone got first hand experience with this? When switching out braces...do the two mount in the same locations? It would be nice if they did as I’m sure there are marks/scratches on the car where the brace mounts to the strut towers
 

94slowbra1

Well-Known Member
Established Member
Joined
Feb 19, 2007
Messages
2,779
Location
new orleans
I'm not sure about swapping to a new one but I can confirm the the 8 fits over a gen 2 2.3 with gt500 set up. May call Mm and see what they say about the mounting locations
 

rccg94

Member
Established Member
Joined
Nov 7, 2015
Messages
66
Location
Denver
If you want to go with a new brace and offset your cost, I will buy your old one (assuming it is in good shape, which it probably is). I just ported my Eaton and have no plans to replace it. PM me if you are interested. Thanks.
 

bfgtim

Member
Established Member
Joined
Jul 27, 2017
Messages
237
My gen 2 vmp tvs showed up today and I took some measurements....I think it'll actually fit under the MM stb-7. It seems to be the same hight as the OEM Eaton (5 3/4")
 

Users who are viewing this thread



Top