JLT, maf fittment

AteYourLS

lets go blues!
Established Member
Joined
Mar 13, 2012
Messages
53
Location
st.louis MO
Have this JLT high boost, just got my MAF
For it. (Vmp BA3000) doing so test fitting and it doesn't look right and thought I'd ask for a 2nd opinion. I feel like there should be a little rubber gasket on the bottom of the sensor as there is a groove that runs all the way around it. s And the bottom of the maf clip actually hits the intake causing it to stick up a little. Anyone know or had this problem? Am I just paranoid. Just don't look right. Trying to figure out how to get pics posted. Been a long time since I've been on this form, life happened and car parts went out. The back burner, but I'm back in action!
 

AteYourLS

lets go blues!
Established Member
Joined
Mar 13, 2012
Messages
53
Location
st.louis MO
Sensor
 

Attachments

  • 1492365711771-1547164367.jpg
    1492365711771-1547164367.jpg
    1.2 MB · Views: 142

Bdubbs

u even lift bro?
Established Member
Premium Member
Joined
Jan 8, 2010
Messages
16,039
Location
MN
The jlt hb intake should come with a rubber gasket that goes between the maf housing and intake.
 

ruthless

Turbo Terminator and TVS Terminator Vert
Established Member
Joined
Jun 2, 2007
Messages
1,439
Location
North of Pittsburgh, Pa
Same issue here with the clip rubbing on the heads. I did get a rubber pad/gasket to seal between the sensor and the intake.

Am I the only person that noticed that those idiots put the air temp sensor directly in front of the MAF sensor? It could have been put almost anywhere but in that spot!
 

Users who are viewing this thread



Top