zdl's latest activity

  • Z
    zdl replied to the thread Chasing a ghost.
    I tried to run a misfire with sct but it didn't give me anything. I'm going to try removing the tune and putting stock injectors back...
  • Z
    zdl replied to the thread Chasing a ghost.
    Yes I did
  • Z
    zdl replied to the thread Chasing a ghost.
    I did find this however when I pulled the plugs 2,3 seem to be not firing properly.
    • 20220512_132551.jpg
  • Z
    zdl replied to the thread Chasing a ghost.
    I did not loosen it to install. I was able to get it wo doing that
  • Z
    zdl replied to the thread Chasing a ghost.
    Its bolted up solid and cannot hear anything in terms of a leak
  • Z
    zdl replied to the thread Chasing a ghost.
    Yes I do have offroad H and they are not the cheapest.
  • Z
    zdl replied to the thread Chasing a ghost.
    No I haven't done that. Can I do that with my sct? I do not have any lites on.
  • Z
    zdl replied to the thread Chasing a ghost.
    I have an 11 gt500 I did a trinity swap. I didn't replace the gasket. My car only has 20k mi on it. Bj is my tuner. He's pretty...
  • Z
    zdl replied to the thread Chasing a ghost.
    My tuner says I have an air leak, but it was a little rough on the dlow rev. I just put a ported trinity on
  • Z
    zdl posted the thread Chasing a ghost in SVT Shelby GT500.
    I cannot figure out what the issue is. I have tried everything. Checked and swapped the injectors. Put a new O2 in. Any ideas?
  • Z
    zdl replied to the thread 2011 trinity swap help..
    That's helpful but doesn't show me everything
  • Z
    So I'm in the middle of doing this and I disconnected everything without taking any pictures and I can't remember where everything goes...
  • Z
    zdl replied to the thread Dyno after 1320 port job.
    1320 junkie I bought it that way
  • Z
    zdl replied to the thread Dyno after 1320 port job.
    I'll be running pump gas, and just found a magnaflow high flow catted x-pipe I'll be adding too.
  • Z
    zdl replied to the thread Dyno after 1320 port job.
    I just got a 2011 500 completely stock. I'm planning on putting a 1320 ported trinty w matching elbow. 68mm dual whipple, 2.4 upper...

Top