i spun a rod bearing so im doing a new motor build and selling this stuff to help fund it. everything is right at 100k miles. pics show damage from bearing(bearing took most of the damage)
i am in the DFW area and would prefer local pick up
block: 250
crank: 250
rods and...
i have most of everthing disconnected from my motor disconnected except the ac and power steering. do i need to drain both these systems to pull my motor from the top??
those of you with cages
did you have to remove the mach amp rack?
did you have to go to a different seat? doesnt seem like there is much room for the bar. if any
if you have any pics to add for reference it would be greatly appriciated. TIA
my car just rolled over 100k and im torn on what i should do. ild like to go twin screw but with my cars milage im thinking i would be better off to do build a new short block and go to stronger internals before i up the power?
opinions please?
just installed a new clutch and cannot press the pedel now. very hard. also cannot manually engage the fork from under the car. centerforce dual friction setup. stock flywheel.
any ideas?
having trouble getting the top two bolts loose on my bell housing to do a clutch swap. any tips or tricks or just something i am missing in my frustration
so i am considering going with a stage 4 ported blower on my 03 with 72k on the clock.
what other mods do i need to do?
Will i have any issues running pump gas? 93 octane here
i currently have a 2.93 and would probably ad a 4lb lower, which i think is a good combo