I have a pretty one-off setup and had been reading here to get an educated guess on how much boost my 4.6L Terminator setup would end up at.
Details on my setup:
Stock bottom end
Stock lower pulley & 2.93" upper
Metco 100mm idlers
Ported M112 blower
Manley valves, ported heads, stock...
I have a pretty one-off setup and had been reading here to get an educated guess on how much boost my 4.6L Terminator setup would end up at.
Details on my setup:
Stock bottom end
Stock lower pulley & 2.93" upper
Metco 100mm idlers
Ported M112 blower
Manley valves, ported heads, stock...
I have some 80 lb injectors I need to get checked out. Can anyone recommend a shop in Michigan that cleans/flow tests injectors?
I'm not trusting Google to make a "reputable" recommendation on this...
I have a freshened 03 Cobra block (new bearings, rings, etc) and when I first fired it up oil pressure goes up really high (90 psi). Once the block comes up to temp, it drops down to 20-30 psi and seems normal, but the fact that it's so high on initial startup it's worrying me.
- I tried two...
I have an AEM 30-1900U Universal EMS with a full custom engine harness that I am considering selling.
I would be selling:
1) Engine Management System with 32-valve naturally aspirated calibration.
2) Complete engine harness with fuse box & relay pack
3) All connectors to install this on a...
Looking for a used 03/04 Cobra M112 in just about any condition. Parts I am concerned about are the front input shaft, bypass shaft, bypass butterfly valve and actuator. Everything else can be used for a doorstop for all I care.
PM or text pics and your reasonable asking price to...