It was just too dang loud. I had the flow 40s, no cats, O/R H pipe and they rocked around town. :rockon:
But on the expressway the drone was rattling the fillings out of my teeth.:cuss:
Had the Dynomax super turbos put on with the same setup. Way quieter, but still has a nice growl...
Removed the hood blanket and drilled two 4" holes behind each scoop to help vent the hot underhood temps here in summertime traffic.
Adjusted the Energy Suspension urethane motor mounts to sit properly in the UPR K member. Seems the engine was sitting a little high causing the air intake to...
Was installing the new wheels and tires last night. The kicker shocks were making contact with the inside of the rear tire. I remember you guys saying that I would need to flip the kickers, but there is no way to do this as they would then make contact with my tokico shocks. So I just left...
Drivers side exhaust manifold has an adaptor to attach EGR line. I searched and found that the female cap to block off this line at the adaptor is m20x1.5. Any idea what threads are tapped in the exhaust manifold itself, should I decide to remove the adaptor. :??:
So my cobra is not dragging the ground anymore and I need to fill up the empty fenders.
Was fixing to pull the trigger on american muscles 17x9/10.5 black cobra R staggerad wheels set, but they do not have a 27" tire that will fit their 17x10.5 wheel?
I'm trying to go 26 OD in the front...
How about a little help with a tire wheel fitment package.
Vehicle is a 96 Cobra that was lowered with steeda goodies. I lifted the car from slammed to about an inch higher than stock. Due to the new mission for the vehicle I had to lift it to get some ground clearance. GMS adjustable...
Which H pipe fits the humps on the 96 cobra crossmember best?:??:
The x pipe I have now does not fit well and hangs low on the drivers side because it does not line up well.
Any recommendations?
It has been a while since I have farkled the 96 cobra, or even posted about it here.
In the last two weeks I have completely replaced the lowered steeda track suspension with a UPR k-member, tubular control arms, 14x175 coil over conversion, fresh rear GT springs and GMS adjustable lower...
Anyone have any luck with sound deadners or insulation. After the suspension and all the mods, the noise is pretty loud.
Its not the exhaust noise, more like the tires on the road.
Any ideas?:shrug:
TREADMARKS
Holy Cow
If I had known that a CAI and chip would make such a big difference, I would have done it a long time ago!
Cobras should come with this stuff from the factory.
Whats next?
TREADMARKS
Hi all,
My 96 Cobra just had a dealer rebuild due to carbon build up on the pistons making contack with the cylinder heads. It was all stock. When I got it back last week, there was a slight skip in the idle, at about 800 rpm. I had the local muffler shop install an off road X-pipe, and...
Who makes the best shop manual for the 96 Cobra?
I am interested in code identification and detailed assembly info.
Thanks in advance for any assistance.
TREADMARKS