Recent content by Toplait

Hey folk, I recently installed another engine in my 2011 mustang GT with Romac Harmonic Balancer on my car. The question is, " will the ATI Harmonic Balancer Procharger crank Pulley bolt onto the Romac Harmonic Balancer?" To work with my Stage 2 P1x kit. Thanks

Yes, the factory master cylinder has no issues.

I would recommend not to cheap out on rotors. The factory GT500 front rotors do the job but are heavy. They weight about 37 lbs a piece. I would invest in a 2 piece rotor.

Thanks, it's a twin 65mm Ford racing.

Okay, so I installed the new o2 sensors today. I Cranked it up and it ran great all the way to operating temperature and then some. The check engine light came on although. After checking the codes. I realized the mass air was not plugged in. I plugged it back in and it still runs like crap...

Hey folks I purchased a p1x stage 2 tuner kit dw95 injectors, dw400 pump, VMP plug in play boost a pump, new plugs gapped .028 for my 2011 GT on 5.12.19. I have yet to be able to get it to run right. First the installation, it was a bit tedious do to the aftermarket BMR K member with...

After a few hours of research and learning about how the wiper system works on our car its actually a really stupid design. I can say this that the part I ordered is not going to work. Going by wiring schematics I found and also the service manual Ford has. When the wipers only work on high and...

okay so finally off work, i stopped by the ford dealer and ordered part# ar3z13k359aa see if that fixes it. Just have to wait till wed.

Hey folks, I got in the car this morning and wipers did not work. They will work on high but do not reset back to normal position. The washer fluid sprayer does not activate them either. I'm on break at work so figured I'd post to see if any one else had that issue.

Any updates or information for the 18' block swap?

Wow that Ford emblem is huge. I don't know why they always have to block air flow with those emblems.

Works great. Takes a little longer to get to operating temperature.

Yea i put the oil heater on mine, "Boss 302 oil cooler." Yea it heated up the water in return. Okay so the install went okay. Radiator is bigger and I had a few issues. First the factory cold air intake duct that connects to my Ford Racing cold air intake had to be modified a tad. The new...

The CSF radiator is made in Indonesia....

I read the reviews on the Steeda website and decided to give it a try. The only negative review I found was on a you tube video of a guy that bought a used S197 with that radiator and swapped it out with a Mishimoto. It was leaking. Not sure how long it was in the car. That CSF radiator is a 2...