Recent content by TheFleshRocket

Well, I took the Cobra for a test drive today (first drive after testing the fan successfully in my garage) and the high-speed fan setting decided to be AWOL. Gonna have to monkey with the fan connector some more, I guess.

I used the pointy tip of my 12V test light to push in around the edges of the connector on the fan side, hoping that it would give better contact with the harness-side plug. After plugging the fan back in, I fired up the car and turned on the AC. The fan started spinning! Assuming that the AC...

I disconnected the fan harness and drove the car for about 10 minutes to get it warmed up. With the coolant over 190F (the temp at which high-speed operation should begin), only the high-speed lead was hot according to my 12V test light. (In my picture above, it's the lead that's at the 1:00...

Never heard of it.. but sounds handy. I'll look into it.

I've already confirmed that the high-speed setting of the fan works if jumpered directly to the battery. I've also already confirmed continuity between the harness at the CCRM and the harness at the fan, for both the low-speed and high-speed fan modes. I'll next check to see if the high-speed...

I did some testing by setting the fan speeds in a "base" tune I had on the device. (Canned tune support is disabled, but I had one "base" tune that does let me change parameters.) Basically, whenever the coolant temp is below the high-speed fan temp, the fan runs in low-speed mode. As soon...

Thanks for the explanation about the low-speed fan signal. I have an SCT Livewire but the car has a custom tune that I can't edit. But.. I guess I could adjust a canned tune to have really low fan temps, load that in the car, and just turn on the key to see if the fan kicks on. I drove...

I found this thread: https://stangnet.com/mustang-forums/threads/03-radiator-fan-wont-turn-on.911298/ I also looked up the fan wiring diagram in the service manual. Interestingly, it states that checking for power at the fan plug, either low speed or high speed should be on, but not both...

Are you positive about the flash only activating the low-speed fan? I am pretty confident that the ECM flash did turn on the high-speed fan--I remember it sounding like a plane was taking off whenever the flash was loading (and seeing the voltmeter drop into the very low 12s or high 11s due to...

I installed the new CCRM and there was no change. When flashing the ECM, the fan only spins up to low speed. (I also tried the AC and it still doesn’t work, either.) So I swapped back to the original CCRM. I then decided to check the wiring at the fan plug. I did another ECM flash and checked...

I think 20-weight and 30-weight are probably not optimally thick enough for a Cobra driven hard in warm temps. The GT500s were recommended to run 5W50, and I feel like that's a lot closer to a good recommendation for the very-similar Cobra motor. I've run Mobil1 0W40 but most recently switched...

Double post. Please delete.

The radiator fan on my '03 Cobra doesn't come on during normal driving, and I'm trying to figure out why. History: I bought the Cobra in 2020 from a seller in Texas. I flew down and when he picked me up at the airport in it, it overheated. We discovered that the radiator fan physically would...

Looking at the descriptions for the S550 and the Cobra heat exchangers, I'm pretty sure they're identical.

I've got a DoB super single heat exchanger ( Super Single Heat Exchanger S550 - Department of Boost ) and the requisite MAF Racing bumper support ( Mustang Bumpers and Core Supports ) and need to get them installed. Does anyone have a list of hoses that are needed to connect the super single to...