Recent content by THE FLASH

Its a 1 owner car, upper and lower pullies, exhaust, tune, coilovers, light bar, nice chrome after market wheels (19x9 and 19x11)...etc it has been in an accident. Ive seen others trying to sell a similiar mystichrome vert in the range of 30-40K. To me thats seems a little high???

The KR is black with the flat black stripes and has about 11k miles. Its a 1 owner car and stock.

Can some one tell me which wire is positive and which wire is negative? One wire is black and the other is an orangish color. i'm asking for a friend. Thank you

Does anyone know if these 2 pads are the same? Which ones are quieter and easier on the rotors? Do the EBC yellow dust the same or more than the HP plus? Thanks for the input.

I have a friend who has an 00 L with 44K miles. His tires are wearing badly in the front. I did a search and found out that there are 2 different alignment specs. Here is my question: he just changed the brakes with ceramic pads the front driverside that is wearing the inner tire the most is...

My car has been making a lot of roaring and clicking sounds and a shifting feeling that was coming from the front driveside. I replaced both front hubs (the bearings were scorched) and the rear passengerside hub bearing (it was demolished). That got rid of all the roaring noises and got rid of...

The bearing has gone bad on one of my idlers, how do you get the allen screws out? I have tried and I think I may have stripped one of the screws :fm: I have tried an allen wrench and even a hex bit, but no such luck. Thanks JC

Are Ford racing parts better quality, same quality, or cheaper quality vs buying an actual oem ford part? My example is: I got a price quote on 1 rear hub (oem) from the dealer for 260.00 (list) which he will discount to 180.00 for me. I also got a price quote (from same dealer) on 1 rear hub...

Ok, I have everything apart except the knuckle (that has the greese fitting)that attaches the rear hub to the rear tie rod. How do you take that section off the hub? Thanks. JC

I have the ford TOB, but it is going out. I plan to buy the Lethal Performance TOB sleeve to have installed. Which TOB is the strongest, longest lasting one on the market? This is such a pain in the you know what. JCg

Long story short, I did a search on the clicking sound and found a couple of reasons why it might be happeing. I did the easiest 1st, I jacked up the car and checked to see if the axle nut was loose...boy was it ever loose. Also there was a lot of play when you would try to turn the wheel/hub...

I have noticed that my TOB is chirping. I have the fiore adjustible quadrant clutch adjuster. I had a DFX clutch, 26 spline input shaft, and the aluminum fly wheel put in my car ab out 3 years ago. I went through my 1st TOB in about 6 months and noticed that my current TOB started to make a...

I have had the MM coilovers and MM C/C plates on my car for 4.5 years and never got so much as a peep out of them until about a month ago I noticed that when I ride over a bump I get a clicking noise, the rougher the road the louder it gets. Also recently their is a shifting noise coming from...

How tight do I tighten the drain plug on the tranny? It seemed pretty hard to get off. Thanks

Will fit on the 03 cobra convertible with the stock k-member, is it worth it to help strengthen the chassis for 35 to 40 bucks?