Recent content by tboothe

Originally a Rossler Terminator 3 but was upgraded to almost a 4 before this past season. Has Rosslers ez stage valve body (internal dump and can leave in any gear on the brake). Has deep aluminum pan, locking lokar dipstick and JW bell housing for a mod motor. The shifter is a quicksilver...

I am looking for an ATI damper p/n 918036. Pm me or email me at [email protected] Thanks

I am looking a for a 6 rib ATI Damper p/n 918036. PM me or email me at [email protected] Thanks

100% Stock longblock, twin 67's, TH400, FAST, E85. These are the first two passes since I finished this setup. Passes made in ABQ, NM. DA at the time of the pass was 6900ft. Tn6tfiKz1yY

Im selling the qa1 bump steer off my cobra. Im going with a foxbody manual rack setup and these wont work with it. They have about 2000 miles on them. 110 shipped. [email protected]

I have a brand new PA bellhousing with the ring adapter, so it will fit either a C4 or a TH400. I dont want to seperate the bell and ring, so they come as a pair. I decided to go a different route so need to get rid of this. Bell is brand new with a SFI manufacture date of August 2009. I am...

I had my T56 out of my 4.6 Cobra gone through and rebuilt at a local tranny shop. Not everything was replaced, but the parts that showed wear and that were damamged were, along with the snap rings etc. Trans has a 10 spline input shaft. There hasnt even been fluid put through it since the...

Im looking for parts for my auto swap. I am putting a TH400 in my 4.6 Cobra, so I need the bellhousing, flexplate, crank adapter, trans coolers with fans, and a quicksilver shifter. LMK what you have. [email protected] or pm me

Had this done a few months ago, thought I would post a pic up. Im real happy with it, havent seen one like it, and designed it myself. The pic was taken the day after it was done.

I am sellin my diablo predator. Its unlocked and for an 03-04 cobra. My local tuner sold his diablo software so I had to switch to sct, and this thing has been sittin around for a while. Ill let it go for 190 shipped. [email protected]

Up for sale is a slightly used Spec Twin disk clutch. This is the P trim verision, which is rated at 1395 ft lbs of tq. This is a 26 spline clutch that fits the ford T56's. The clutch has 800 miles, 500 break in miles, 1 track day with only 1 gear ran through it, broke trans goin into 2nd. I am...

I decided to take another route with the fuel system, so I dont need these. Set of siemens deka 83# high impedence injectors. They were recently flow tested and checked, 1 was out of spec and was replaced. Ill let these go for 350 shipped. [email protected]

Sold

Sold

Sold