So, like many others here over the last few years I had some issues with the stock Pistons in the original Terminator shortblock and thought It was finally time for a rebuild. So I did just that! Only this time I went with a Teksid block and a brand new set of CNC ported heads and added some...
So, like many others here over the last few years I had some issues with the stock Pistons in the original Terminator shortblock and thought It was finally time for a rebuild. So I did just that! Only this time I went with a Teksid block and a brand new set of CNC ported heads and added some...
I just completed a Teksid build about a month ago. So while I was at it I stepped up to CNC ported heads and BBK longtubes. Other than the things mentioned above the setup is the same. I put down 615rwhp and 514rwtq on 18 psi and 679rwhp and 576rwtq on 23psi. Those are SAE corrected numbers too...
Since installing my new built Teksid I keep getting a couple of codes coming up and have tried clearing them with my sct tuner and they eventually come back.. I've even uploaded my tune back in the car to see if that would correct it but no luck..
1st on is (P1000 obd readiness test not...
As the thread title states Im looking for some pics of DSG Cobra's with black FR500's. I currently have some Anthracite FR500's and am contemplating plasti-dipping them gloss black but cant seem to find any pics?
Heres mine now, Im getting bored with my wheels and would like to change it up a...
Will increased compression ratio increase my Boost #'s?
A short summary of my setup first... I asked for 8.5:1 ish compression ratio from the shop that built my shortblock, I get it back friday and he tells me it is now 9.15:1 compression ratio with the .20 over Manley 11cc pistons. Im...
Just a quick question, have any of you ever upgraded the timing tensioner guide pins when you built a teksid based engine? The stock ones are 6mm and there are some 8mm ones from cobra engineering available, would like to make sure the 6mm ones will hold up and just curious if any of you have...
I purchased a new set of CNC ported heads last year so these are now for sale and come complete and fully assembled with cams also. They were built in december of '02 so they have the revisions for the dreaded "head tick". $1075 obo
I will post pictures later this evening.
Jared
Passenger...
I purchased a new set of CNC ported heads last year so these are now for sale and come complete and fully assembled with cams also. They are were built in december of '02 so they have the revisions for the dreaded "head tick". $1075 obo
I will post pictures later this evening.
Jared...