What kind of power are you making and what gearing to hold that type of speed through turns 1 and 2. My 99' cobra has a 3650 and 330whp with 3.90's and I'm stuck around 125mph in 4th gear.
I'm looking for a local shop to go over my 99' Cobra and make sure everything is good to go for a track day and perform an alignment. I use to do all the work myself and have west end do the alignment but they are booked up and I don't have time anymore and I'd like to make it to willow springs...
I'm looking for a local shop to go over my 99' Cobra and make sure everything is good to go for a track day and perform an alignment. I use to do all the work myself and have west end do the alignment but they are booked up and I don't have time anymore and I'd like to make it to willow springs...
I have a set of 95' cobra r replica rims for sale. Two are 17x9 and two are 17x10.5 with a dish. They are black with metal lip and in good condition. They have 275/40/17 toyo RA1's that I used for road racing that are used up and really only good for burnouts.
Typical 5x114.3 bolt pattern and...
I haven't tried that. I know the holes are a bit elongated so that might work but effectively that's more negative camber.
They suggested I run -3 degrees camber, which i don't mind as the car is mainly a track car but I don't want to chew everything up.
My biggest problem right now is the...
So what did you do? Here they are mounted with 0.8" spacing with 275/40/17 R888 tires. I moved the spring perch all the way down so i can manipulate the wheel travel and articulation. This is pushed up as far as I can go before it starts coming off the jack stand.
I included some photos of it.
Five years ago I bought 17x9.5 + 38mm offset RPF1's and now five years later I got around to doing the wheel studs and installing the Enkei's. Unfortunately, I forgot what I had bought the 39/64" drill bit for and I didn't rheem the front hubs and I ended up messing them up. I bought a new set...
Well five years later I got around to doing the wheel studs and installing the Enkei's. Unfortunately, I forgot what I had bought the 39/64" drill bit for and I didn't rheem the front hubs and I ended up messing them up. I bought a new set of timken's, rheemed them, and installed the new studs...
Hey guys, my NT555's are dried out and cracked after 15k miles, 35k miles total on the truck, and I need to replace them. According to Nitto's website the G2's and NT05's are no longer made in 295/45/18. I want a semi sticky tire, I don't go to the track, that can handle the 450hp and 540tq my...