Recent content by SlowSnake

Looking for one that will fit kooks long tubes. Who has one?

I need a video or sound clip of manifolds,O/R prochamber and super 44 flows. Can someone point me in the right direction? Sent from my DROIDX using Tapatalk 2

Would it be more beneficial to run a separator or a breather on the passenger side head? Im gonna run one or the other but which is best? I don't wanna clean my intercooler again any time soon Sent from my DROIDX using Tapatalk 2

I just got the cobra back together from installing mm urethane IRS bushings. Now I have a bumping and it seems to be the rear. It only happens with the car on the ground with the suspension loaded. I have looked at everything I can think of. I don't see any point of contact for anything to be...

I have a 10th Ann cobra and on my drivers seat on the red part my black belt has rubbed off onto the red. I tried to rub it off but no luck even tried mean green and awesome and they didn't work either .....any suggestions? Sent from my DROIDX using Tapatalk

What's the easiest way to raise the headers or can u? I have hr race springs with upper isos and the collectors are about an inch and a half below the subframes. Will getting new isos help? What can I do? I'm tired of scrubbing on everything :( almost to the point of selling the headers...

Im replacing header gaskets on my cobra and I have a couple of questions. First I need some new nuts cause mine are rusty. Can I get stainless ones anywhere? Do you have to heat cycle then pull everything back apart and retighten? One more I found a few of them loose from vibration I...

I have Kooks long tubes and remflex gaskets( guaranteed not to leak) well I have a leak.....Its on the passenger side. I hit a bump earlier today but didn't notice a leak until I got home. Does anyone know anyway to tighten up the bolts without having to drop the k member...I have done this...

what is the part number for the pcv hose assembly on the drivers side?

I just installed a CF DF clutch in my car and for some reason when I bolted everything up and fired her up everything vibrates. you can feel it in the steering wheel:nonono: the firewall adj. also hits the valve cover I cant figure out what i did wrong. :shrug: can anyone help? also the...

does anyone know where this link went? Kooks LT’s, Kooks O/R X, Borla Stingers http://www.maca-online.com/videos/Re...t-WOTClips.wmv anyone have this setup? I wanna swap catbacks but its between stingers and magnapacks. someone help me decide

Installing a CF DF clutch in my car . the car has 4X,XXX miles on it do i need to resurface my flywheel? How can you tell?:shrug:

I want to get a tubular K member but don't know which one to get. Not getting a MM don't want the wider stance in the front. any other good options? :shrug:

I blew out the passenger side gasket on my Kooks headers. Does anyone know of an easier way to replace the gasket other than dropping the K member? :shrug:

Whats the most popular K Member? Whats the difference in them and what would be the best one for the money? I really don't wanna spend $650 on a MM K what would be a good one? tried searching but get database error :shrug: Also do you have to use tubular A Arms or can you use the...