Need an o2 sensor wire harness. Connects under airbox, harness runs around front of engine to o2 connectors and one other connector. I'd assume 87 to 93 should be the same. Unless you specifically know it's different. Car is a 93 GT. PayPal ready. If your not running your o2 sensors, let me know...
I'm sure we've all seen Toby's thread on his super clean Tork Tech install?
Was gonna copy his design on his coolant crossover pipe. However, on my Tork Tech crossover, there are the two main tubes that go to each side of manifold. But mine has a 3rd, smaller coolant line coming from the...
Anybody know what the stock dimensions are on an 04 heat exchanger?
Need to get a bracket built at work for a HE coming Thursday.
Really appreciate it.
Got my TT kit finally buttoned up. Drive tune loaded and started. Went real smooth. Fired right up and ran awesome. No leaks. Couple minor set backs. TPS had to be lengthened, along with IAT. My stock cobra MAF bolt holes didn't line up with the bolt holes in my JLT High Boost CIA.
Also had...
Finishing up my Tork Tech build. Have a few parts if anybody is interested. Cheap.
All parts are stock.
Throttle body - TPS - IAC - K&N air filter - Plenum - EGR - Intake manifold - MAF - Injectors (pink 21.5#) - Snorkel intake and tube
Car just turned 80k but it was babied its whole life...
Got the pulley bridge on. Alternator mounted to bridge.
Now, I personally called TT and talked to Bill a couple weeks ago when waiting for my kit to ship. I had asked if I use my factory sized accessory belt or do I need a custom sized belt. He assured me that I use the factory belt.
So, I get...
Ive been reading tobynt thread when he did his TT kit. Flawless install.
http://www.svtperformance.com/forums/showthread.php?826230-Tork-Tech-Terminator-Install
I was going to vent both my valve cover vents to my Moroso oil breather catch can. His was a Jegs brand. But basically the same...
Vacuum routing question. There are 3 nipples on back of blower (4 total). One large upper 1/2", an upper and lower 3/8", and the one on the plenum.
FRPS, Vac/Boost gauge, and upper nipple on boost bypass valve to 3/8" lower nipple back of blower. Boost side.
Small diameter canister...
Been about a month. But the day has finally come. Should have by weekend. Now to begin the tear down of my GT and get it prepped and ready.
Question. I bought NGK TR6 spark plugs. What should I gap them at?
Friend with an 03 Cobra says .035". Just want to make sure its not something different...
GT only has 8" wide front wheels. Used these to widen out the front a little. I eventually went with 1" spacers. Would be perfect for a rear 10.5" set up that is close to rubbing.
Besides a little rust residue from wheel hub and wheel, they are in perfect condition. Some steel wool and they...
GT only has 8" wide front wheels. Used these to widen out the front a little. I eventually went with 1" spacers. Would be perfect for a rear 10.5" set up that is close to rubbing.
Besides a little rust residue from wheel hub and wheel, they are in perfect condition. Some steel wool and they...
Buying new seal kit for my stock cobra fuel injectors. The kit comes with new filters. Either plastic or steel filters, but not both.
Should I get the plastic or steel? Or does it really matter?
Thanks in advance for any info.