buddy of mine broke the tail shaft housing on a 2004 Cobra T56 and we’re having no luck finding a replacement. If anyone has a tailshaft housing or a lead on one please let me know.
Thank you
Okay so started it again this morning. Got to log a true cold start this time. I split it into three parts this time. I think the most important is comparing the AFR at the end of each log. By the end of this log it was idling around 12-12.5. This is still the exact same tune as the other...
Didn't end up having much time to play with it today but I was able to get two logs. Both logs are the same exact tune, the car just sat for about two hours after the first was taken. The first log is shorter and unfortunately didn't include a cold start but it does show the stabilized idle...
I'm in open loop so the O2's shouldn't be affecting the commanded fueling but it sure seems like it is. The front O2s have already been replaced. Assuming this is the issue, do you have any suggestions on troubleshooting or fixing?
I'm hoping I'll be able to get multiple datalogs tomorrow to...
The units for MAF here are volts. Your transfer function should have that in the third (?) column.
The first thirty or so seconds is 15-16 afr then transitions down and stabilizes like you say. I will make a 5% change and log again. The biggest issue that I see is that it drops a whole point...
Here is a log of a warm start, 150 or so startup temp. It has more than you asked for but let me know if anything stands out to you guys. I'm sure I'll still grab another one tomorrow. Thanks.
No big cams. I can go back to CL to log STFTs.
The adjustments I made to MAF were at operating temp. 190-200.
Correct MSE3 is 2001 cobra.
Right, the af readings I've been making changes off of has been after three or four minutes at full operating temp. I remember it taking time to settle...
The lean start up is on both cold and warm starts. As far as I can tell, the Startup Cold Fuel table shouldn't be used until temps drop back to 110 in my tune.
I've leaned it out with the MAF a couple times. With the FIC1000s it was first idling at 11 or so. Reduced MAF in the appropriate...
Right I'm logging in livelink. I'm currently tuning open loop so no stft's. As far as I could tell, injector duty cycle isn't available on my ECU (MSE3) if anyone knows otherwise let me know. I'll log a true cold start tomorrow. I could turn closed loop back on for stft I suppose but I don't...
O2 voltages were around 0.45-0.5 after about 5 minutes of idling. Took about 2 minutes for them to get to 0.15-0.20. I'm not sure where they should be but I'll do a quick google.