Hello guys, I have been away for a long time, I figure I would post a couple videos I've made of my competition orange Terminator. It has been stored away for a while, I finally got it repainted a couple months ago. Now I am looking for some new wheels, as well as, getting the seats redone. I...
Hello guys I'm wanting to do the plugs on my car and just wanted to get some opinions on what plugs I should buy. Its got 70K miles on it with no major mods just CAI, longtubes, X, catback, and a can tune. Just didn't know if I should stick with stockers or go another route.. Thanks in advance...
Hello, just wondering if someone could tell me if an 03 Harley has the same rear end as my Lightning. Here's the deal... A buddy of mine wants my gears and I want his so, i figure it'll be easier to swap out the whole rear ends. Thanks...
Hello guys just have a quick question... What's the recommended air pressure to run on the nitto DR's. I notice the are starting to wear on the outside. Thanks..
Hello guys, well I got a new job and I'm leaving Grand Prairie. New job is in Lockhart (Austin area) and know I haven't made it to any of the DFW meets but maybe it'll be different down there since I'm not going to be traveling like I did with my previous job. So far I only have the Lightning...
Hello guys, just wondering if anyone can post a picture of their truck with bell tech spindles and hotchkis springs. I've got spindles and cut spring right now and I'm wanting to changing my current set up, its too low and its rubbing every time i hit a bump. Thanks in advance.
:beer::rockon:
Hello all,
Its seems that the L did not like the mods I did to it last weekend. :cryying: I cleaned the intercooler and got the blower ported also insalled belltech spindles and the truck drove fine for a day. Now its having problems shifting. its not slipping it feels more like its not...
Hello I am interested in picking up a set of Bear rotors for my 00 L and was wondering if you had them ready to ship. Also, what kind warranty do they come with? Thanks in advance.
:beer:
Hello all! Got a quick question. It's time for some rotors and I'm wanting to go with either Baer or EBC so my question is where is the best place to get a set?
Thanks in advance :beer: