Ok so I sold my 11 gt500. I am selling a few brand new things never installed.
Metco pcv adapters I was going to do a custom catch can setup. Paid 160 asking $100 shipped.
Camber bolts 30 shipped.
Tr6 plugs brand new. 25 shipped
Blow fish racing shifter support for tr6060 trans asking 300...
Currently have a 13-14 setup ready to go in my 2011 but I was thinking about getting it ported. So my question is who offers this and who should I use? Thanks
Sent from my iPhone using Tapatalk
I do believe these are arp head studs. They are for a 4.6 used asking $150 shipped
You can call or text at 901-493-1162 for quicker response
Sent from my iPhone using Tapatalk
Asking $150 for this low mile lightning oem lower
Price is $150 you pay shipping
You can reach me at 901-493-1162 for quicker response
Sent from my iPhone using Tapatalk
So first up is a gt 500 k&n intake with filter.
$100 you pay shipping and pay pal fees.
Next is a metco idler pulley pn msi-90
$120 you pay shipping and PayPal fees
Next is a set of 32lb injectors ford I do believe they are oem for a 2009 or 2008?
Needs a few o rings very low mile take...
Fuel pump driver module fpdm $50
Brand new ford motorcraft idle air control valve. $60
Fuel rail pressure sensor $60
Steering column gauge pod $50
1 inch by 50 ft tread stone Kevlar wrap good for 2500 f $40
2 brand new revised gt supercar pumps paid $220 shipped
Stock cobra fuel rail...
Hi there I recently picked up a 2011 grabber blue gt 500 it has pulley,intake,tune,exhaust. I am currently getting parts together so far I have tss billet oil pump gears. Mmr billet crankshaft gears. L&m custom ground cams with titanium springs and retainers. So I was looking at getting the new...
Ok so I am in the process of purchasing a 2012 gt500 i have had several Cobras but never a gt500. Couple of questions. So how much power can a gt500 handle safely?
How much power can you run with let's say stock fuel system with upgraded injectors and bap or are they not needed? I guess what I...
Motor has 15k miles all Na supercharged has been on for almost 500 miles all rest of parts brand new with just break in miles on them. seats are corbeou cr1 stock rear seats. So first things first the motor.
Motor consists of mmr 900 4.75 se stroker
Arp head studs
Arp rod bolts
Manley notched...
Ok so the other night I parked my cobra it sat for an hour. Came back out and bam will not start but turns over. Just a little info before this the idle was hanging a little bit and was sitting around 1k to 1200 rpm idle a little rough. Fuel system consists of kurgan triple hat with dual gt...
Hi just as stated I need a write up or wiring diagram on the iat 2 sensor for my 2001 cobra eaton conversion. Or can i use the iat 1 and just plug it into the iat 2 sensor? I have searched 01 venoms posts but all of his links with the write up are broken. Thanks for any help you guys can provide.