Recent content by Radron2626

I have one, GT500 OEM in perfect condition. Used on my 2007 GT500 if anyone is still interested.

I have one, best mod for the car ever. Works great, easy to set up, easy to use. I use the tallest blocks that came with it, and they work good. Read the threads above.

Beautiful looking car! Nice write up on the axle movement. I agree, it isn't much, but could be enough to rub in some set ups. The live axle/pan hard bar is definitely not the limiting factor in these cars when cornering hard. I have a Gen 2 Whipple 2.9 in mine for power as well.

I am in the middle of converting my car over to more road racing as well. I will be going with the Cortex Watts link as well. Right now I have 305/35/18 Toyo R888R on 18x11s, on all Four corners, and Cortex JRi adjustable coilovers. If all the watts link does is settle rear end down through the...

Sorry to here OP, never fun. I hope you get it taken care of. It would probably be a good time to pull the motor since winter is coming and just go through it 100%. Wether you replace anything or not, at least you’ll be fully satisfied everything was doubled checked.

Awesome Numbers! You said there is more boost? What was the boost #s before on the Gen 2 vs the Gen 4 with the same pulleys?

It is a Gen 2. Not sure what the difference is for Gen 4-5, I know they make a lil more hp per boost, as they are more efficient. I am just not sure if the pulley sizes create the same amount of boost or not.

2.9 Whipple, 10% lower, 2.85 upper, should be 21-22psi at sea level. 18psi in Denver (5280’ elevation). Ask me how I know...

Why not run both? 750whp on pump, with the occasional pulls seems to be just fine with these engines. If you want/need more power, then yes, make the switch.

I have the 2 Piece True Forged Super Sport wheels that look similar for these if any one is interested as an alternative.

Selling a used GT500KR strut brace. It says Ford Racing on the center. Great looking piece. No bends, just normal wear from installing and uninstalling. $350 plus shipping.

Haha yea, so does mine. Constantly dropping down to 15psi. I would say that’s your best bet, and just check them with a gauge whenever.

Not sure, I have always bought just the 4 pack valve stem style with syncing tool, and never had a problem.

Does anyone have a 2.75” Whipple Pulley laying around they would like to sell? Thanks!

Yea I just watch ECT, iat/iat2, volts, spark, ect on mine. Use it for uploading tunes, check DTCs if needed, RPMs I have set to match my OEM Shift light. I also have separate gauges for boost, fuel, afr as well.