Recent content by Phil04Cobra

Matte black with brushed aluminum text.

Sent

Thanks! Appreciate it.

Here's another design / color I made recently. Raven black powdercoat with gloss black vinyl lettering.

Added text to the custom rad support cover I built. Raven black with gloss vinyl

They are 18" afs replicas mine was too low. I had to raise it up.

Here is a rad support cover I developed. Had a couple small hiccups with it and just finishing up the last few details and revisions. Almost ready to go. .

I used to have H&R race springs with no isolators It sat really nice. Now I'm running coil overs up front with H&R sports out back with no Isos. It's almost too low now but I'm gonna try it at this ride height for a while.

Any updates on this ?

I find it helps. Especially if you're not running a catch can , oil residue gets in there and can clog it up. I spray throttle body cleaner in there then clean it out good with a q tip. Do the same with the throttle body. I'm installing a catch can on mine soon.

305/35/18 here with rolled fenders. I like the beefier sidewall as opposed to the 315/30.

Clean your IAC with some throttle body cleaner , make sure the little valve isn't stuck as well. I'd also check the throttle positioning sensor. Make sure it's set properly.

Thanks a lot ! I have already produced a bunch and sold them. Pm me and we will work something out !

Hey guys , I posted up an thread in the terminator section about this too but thought I would share here as well. Over the past while I've been working developing this rad support cover for my 04 Cobra and finally have a finished product. It's laser cut from 18 gauge aluminum , I make the...