Recent content by Ontariomystic

  1. O

    VMP TVS Gen II 2.3L: BNIB

    Interesting...won't sell it local either unless I pay $4400 Cdn which is more than $200 USD above asking price and no shipping either
  2. O

    VMP TVS Gen II 2.3L: BNIB

    Will you take $2900 shipped to Niagara Falls NY? Sent from my SM-G960W using Tapatalk
  3. O

    Gen3 VMP TVS

    What is the Pre-sale deal?
  4. O

    MAF disconnected, no CEL ?

    Perhaps the "load with failed Maf" table is dialed in better on some cars more than others. I've seen it in the Sct software
  5. O

    Speedhut gauge color

    Which rev-glow color matches the stock cluster best? Bright or Dark green?
  6. O

    Division X fuel hats

    Can you convert one of these into a returnless setup by removing the factory return fittings and plugging them?
  7. O

    Whipple 3.0 pulley

    Pulley is basicly brand new, was installed but never had car retuned for the 3.0 pulley so less than 100 miles use. $100
  8. O

    Jlt Carbon Fiber RAI w/ upgraded CF shield

    Gen 1 Carbon Fiber RAI and upgraded Carbon Fiber shield. Used for one summer or approx. 250 miles, S&B filter is brand new in box unused. $300
  9. O

    Whipple pulleys

    I have a Whipple 3.0 and 3.25 pulley, both are like new $100 shipped each.
  10. O

    Whipple 140 leaking oil from rear flange

    I've noticed oil is leaking slightly from the flange that mounts the elbow to the blower case. Anyone had this problem before? It's obviously from engine oil sitting in the elbow drawn in through the PCV. There must be some sort of gasket between the surfaces that is not sealing properly...
  11. O

    Stock GT500 blower height?

    I need to know the height of a stock blower from the mounting surface to the hightest point of the inlet. It's for a custom install and I noticed the blower gets taller at the back which may cause clearance issues.
  12. O

    Kooks headers and catted X-pipe

    Headers are like new, P#6008CX only 350 miles of use. Fully welded collector. 1 5/8" primaries with 2 1/2" collector. X-pipe has the new Magnaflow race cats. Fit 96-04 4V engines. $1000
  13. O

    Backfiring with longtubes?

    I get alot of backfiring with my Kooks longtubes when decelerating. My tuner says its related to using 60lb injectors. Anyone know how to minimize this issue?
  14. O

    Spec Twin vs Ram Twin

    Looking into a twin disc clutch. I'm leaning towards the Spec cause it is an easy bolt in vs the ram which is more difficult and requires adjusting the pivot etc. I have long tubes so I don't want to have to pull the tranny more than once to make adjustments. Why aren't more guys running the...
  15. O

    Blew the FRPS on startup

    I'm running Ford GT pumps with the Fore hat so no PPRV, on startup the engine started and quit. Then would not start again. Checked the FRPS and gas was spitting out the vacuum port. Luckily I had a spare and the tools to change it. Has anyone blown one on startup? Seems like my fuel...
See more

Top