My car has been driving fine. 96 cobra daily driver only 74,000mi. I went to start it up wednesday morning and it won't start. It cranks but it seems slow. Plugs are getting spark and there is plenty of fuel in the cylinders.
It hasn't thrown a code. I guess because the last time it drove, (2...
SOLD
1996-2004 UPR Chrome-Moly K-member kit. This kit includes 12" 350lb springs. It is 100% complete with everything UPR includes. I took it out of the box for inspection and started to bolt up the k-member to the car and then decided I didn't want to go through with it. The control arms are...
I tried searching for irs in our thread but didn't get anything.
Has anyone done this/have pics? I'd like to know the locations where it would have to be drilled. Does our driveshaft work, brakes? How big of a pain was it? Was it worth it? any comments. I know the axles are slightly longer on...
Hey guys. I've got a 10 inch mtx thunderform subwoofer enclosure for sale. It's new in the box only opened it to check it out. This piece sells for $350 on Crutchfield http://www.crutchfield.com/App/Product/Item/Main.aspx?showAll=N&g=530&i=236FMC1T45&c=3&tp=113&avf=N
Comes complete with...
I'm looking to get upr's front k-member kit with the coil over set up for the front. I'd also like to have the same adjustablilty and setup in the rear, however it doesn't look as though upr makes a rear kit. I know mmr and mm make kits but then I'd still be mixing and matching.
So is it bad...
i've got my heater ground grounded to the block and the system ground grounded w/a battery ground on the frame. i've also tried grounding the heater ground to the firewall to no avail.
it's an innovate lc-1
the controller works great except when i let of the throttle the voltage peaks and...
im getting some guages from a new local company and don't have any experience with them.
wheres the best place/best way to place the sensor for the water temp guage?
anyone hve any links to how to's on our cars or engine pics showing the sensor setup?
thanks
i pressed my wheel studs into the axle on a press but unfornately some of them aren't in perfectly straight and the wheel won't quite fit on them.
i installed the axles and i've used washers and a lug and torqued them down to 90 ft lbs but they still didn't straighten up enough.
also tryed...
just changed the rear pads and now when i engage the parking brake with the rear off the ground the tires still spin.
the cable still moves and compresses the spring when the cable is engaged but the axle still spins
i downshifted to 3rd at about 70mph and then when shifting after this my clutch felt as though it tightened up quit a bit on me. it also seemed to be stiffer when shifting into 2nd and 3rd. it feels almost as though the cable got stuck around something but it doesn't happen during ever shift...
BBK performance part #1555. new in box. 3-piece polished aluminum pulley kit
fits 1996-March 2001 4.6L Mustang GT/Cobra -ford changed the water pump pulley midyear on the 2001's.
$100 shipped
Quoted from bbk's website
"Made from aircraft quality aluminum alloy these BBK under drive front...
I just got the Ford Racing axle girdle M-4033-G1 and they recommend a bearing cap stud kit M-4034-A for it.
Where do these studs go?
and should I spend the extra $38.00?