Recent content by NVENEM8U

Ed's 09 gt on spray - YouTube

just a bolt on/ spray'd 3v :) car number 009 .....mods are : lt's, o/r x, axle back, 1 piece ds, 3.73 gear, frpp intake, bbk twin 62 tb, ngk plugs one heat range colder, lca's, uca, bmr housing bushing, front swaybar delete/ upr lower rad support, racestars, and a tune. plus a 150 shot

used a few thousand miles, cosmetic damage on the lower portion of the cats. (outer case)cats are intact and operate correctly. no leaks or problems aside from cosmetic blemish. asking $300.00 + shipping will ship or will meet half way if in a reasonable distance. fits kooks or pypes longtube...

-------------------------------------------------------------------------------- 09 gt auto with bolt ons, kooks headers, catted x, 3.73,wms ram air, frpp intake, tune, stock converter, stock suspension, goodyear eagle drag radials 275/40/17....125 shot....57 n jet 35 f jet 125 shot ...

i have a single turbo 01 cobra (70mm .68 ar exhaust) and Im going to the track again soon with a few changes and I want some opinions. I have a 2 step on the car so leaving in boost will not be a problem along with all the tubular goodies and drag shocks/struts ect. Im currently running the...

Delete

in good condition and ready for use 50 bucks plus the ride ......

in good condition and ready for use 50 bucks plus the ride ......

01 mustang cobra convertible 91xxx miles (turbo has been on for 10k miles) on3 performance turbo kit (completely cermaic coated hot and cold sides) 70 mm masterpower upgrade 60lb injectors SCT x cal 2 Borla mufflers qa1 tubular k - member qa1 control arms upr coil overs alignment...

Wanting to take my turbo 01 cobra to the next level by removing the oem teksid sb and forged crank and adding low mileage 03 cobra rods and pistons. I expect some will frown on the used pistons but i got an awesome deal on them and they should be fine for my goals. Heres my plan let me know...

delete

I have a turbo 01 cobra and im getting ready to do a forged bottom end. It has a teksid alum block and stock 01 heads. Im wanting to go with the fel-pro permatorque MLS head gaskets however theres different part numbers listed for a 01 cobra vs a 03 cobra. since im boosted do i use the 03 part...

Im going to be running a single aeromotive 340 stealth pump combined with a kenne bell 40 amp bap wired pre fpdm with a 10 gauge wiring upgrade to the fpdm before the bap and after the fpdm to the pump.( approx 433lph flow ) Will i need to upgrade the fpdm due to the higher amperage draw of the...

01 cobra with gen 1 on 3 kit 7psi 478/470 but gets lean over 5500......out of fuel pump