https://fordracingpartsbydonwood.com/engine-parts/short-blocks/5-0l-coyote-aluminator-na-short-block-m-6009-a50naa/
This is the gen2 but I just put one in my car, no problem with using stock 13-14 heads or any parts off my 14gt stock motor. Except for hurricane Harvey flooding my car. So I will...
I ended up overnighting a steel clutch alignment tool from summit racing, transmission went in with little effort after that. Appreciate all the advice
I'm trying to install my t56 magnum , and every time I try to stab it I have about a 1" gap between the transmission and bellhousing.
I've taken the pressure plate off and re aligned the clutch discs to see if that was it, tried again and same problem.
If anyone has done this install and had...
Been a bit since update, but have been on vacation. Got the motor back in and supercharger mounted. Should be putting the tremec in this weekend if work allows and finish the charge piping and fuel system.
After that should be about ready to fire up and tune her
Got started putting the aluminator on the engine stand to assemble and noticed the bolt for the lower passenger side did not want to thread(just my luck). It looked like it was banged against something in the factory or during assembly, once we got to looking at it it was noticably d shaped. The...
I had the same thing happen on my car last year around October. Car wobbled and pulled power but my TC light came on. I pulled over and shut car off then turned it right back on, it's never done it again since that one time so hopefully it was just a one time deal.